文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 能源/化工 > Application of Models of the Wind Energy Conversion System to Wind Power Dynamic Analysis
侵权投诉

Application of Models of the Wind Energy Conversion System to Wind Power Dynamic Analysis

wind power control and design

Therefore, the rigidity between the wind turbine and the induction generator is very low. (4) Induction generator Modern large scale WECS generally made use of induction generator connectedto grid because of its low unit cost, reduced maintenance, rugged and brushless rotor(squirre1 cage type), etc. Some capacitors across between the induction generator terminal provide reactive power to Iexcitation. However, the wind energy which could be utilized major distributed 1111 coast or remote areas. High wind speed sites suitable for wind turbines are oRen remote&om a strong electrical connection point. The cost of a new circuit direct to the nearest p~ n a r y substation may make a project uneconomic, while planning permission for new overhead line is increaslngly dSicuIt to obtain. Therefore, the we of the existmg rural distribution network for connc:ction of individual wind turbines, or small wind fanns, becomes attractive. Connection to the distribution system at the end of a long feeder leads to a very low ratio of network short circuit level to embedded generating capacity, with the consequent problems of both steady and dynamic voltage fluctuations. In th13worst cases, also, the wind power turbulence may lead to voltage unstability. For analyzing dynamic performances of the WECS connected to the grid, the models of the WECS were developed, and then a relationship of the SCC with the wind power penetration of the WECS should be investigated.

WECS and the grid. The models of the W C S are as follows:

2.1 Wind speed model For simulatmg the wind speed acted on the blade of the wind turbine, the wind speed can be of the form of four-component model[ 11:= VB (1) whke V, represents the wind turbine wind speed(m/sec.), V’ represents base wind

vw

+v,,+vm+vm

speed(m/s),where it is a constant. This component is always assumed to be preseit in studies where the wind generator is required to be in service. V,, represents gust wind speed(m/sec.), Vm, represents ramp wind speed(m/sec.), and represents random wind

vm

speed(dsec.)

2.2 Wind turbine models The wind turbine consists of blade, hub, gear box, etc. Due to a low rigidity and a big inertia of the wind turbine, and the models of dynamics of the WECS could be shpMed[Z, 3, 61 as follows: (aU of the per unit values are based on the wind turbine rating below)

(1) Blade model The wind t

orque acted on each blade, can be expressed as[3]

Mw@. u.),

where

/z= OR/&

tip speed ratio, p represents ar i

2. Models of the WECS stochastic variations of the wind speed leads to a fluctuation of the voltage when the WECS connected to the grid. The WECS is usually in dynamic processes during running state, and the utility is disturbed by the WECS. Had the wind power developed to a certajn scale, and yet the penetration of the WECS exceeded to a h i t which ratio of network SCC to the wind power connected to the grid. As a result of, the voltage or fiequency of the network rmght bring about collapse. Therefore, tlhe large scale WECS connected to grid should be considered the wind power penetration impacts on the network and interactions between the

density(k%/m3), R represents blade radius (m),n represents rotational speed of the turbine shaft(rad./sec.). The wind turbine blade aerodynamics were characterized by non-dimensional curve of torque coefficient Cp as a function of tip speed ratio h for various blade pitch angles. The charactedics are

shown in Fig. 1.[3]

-1407-

Application of Models of the Wind Energy Conversion System to Wind Power Dynamic Analysis

上一页第2页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email