wind power control and design
0.05
0.04 0.03
a The induction generator w s represented using the classical Park[4]equations. These equations are, in normalized form, represented by using a synchronously rotating reference frame[S] as follower. It is noted that the per unit values are based on the rating of the induction generator below.
0.02 0.01
U*= -(.t "
+ jxy.+ 8.
(5)
p=40
5
10
15
20 - A
where, U s, r,, represent stator voltage, current is, and resistance, respectively,@. u.); X, X,,Xm
Fkg. 1. Wind turbine characteristic curves C= f (A,/.?),
,
represent stator reactance, rotor reactance reactance, respectively, (p.
(2) Hub model .Due to a large inertia of the wind turbine, the effect of torque fkom hub to gem box is similar to that of the reheated steam on the steam turbine shaft[5]. Hence the relationship between wind torque, M,, and the torque developed on the turbine sha&
and
mta uul
u) .;
x'= x,
+-
X2Xm
represents transient reactance, (p.
XZ+ X m
u) .;
I?*
represents transient voltage,@. U) -.
On the other hand, the rotor transient equation was of the n o d form:
M,,is similar to
the one that represents the reheat stage of the steam turbine. Thus; (3)
(6) where, XZ+ X m CO= -, (sec.), represents the rotor
24%
where
is a time constant.
(3) Gear box model The wind'turbine is generally coupled to the induction generator shaft through a gear box of ratio G, . The dynamic characteristic equation that relates the torque on the two sides of the gear box is given by[3,5];
wind time constant when the stator wind was placed in open circuit state; x= x,+ xm represents a reactance. Evidently, the rotor swing equation was as follows:
-=-(Mm - A l e ) dt T, where,M,,, electrical torque,
A
1
(7)
and Me represent mechanical and respectively,@. u.); s,
dn 1 -= -(Mt - G,Mm) dt 2; where
@.
(4)
u.), represents slip; T, (sec.), represents indu
ction j generator inertial time constant. The electric powerP,, (p. u.) of the induction generator is
I;
represents the inertial time constant of the
gear box.
2.3 Induction generator model The simulation of the induction generator is based upon the following assumptions: (a) Saturation effects and core losses are neglected; (b) Space harmonics on air-gap flux are ignored; (c) The stator transients are neglected. where, Re( ) represents a real component. 2.4 Capacitors model The capacitors were represented a parallel reactance -jXc, and across the induction generator terminal.
-1408-

W6)Grid integration of wind energy into power system_生产/经营管理_经管... ZnCl Demand side energy storage application NaS batteries, redox flow ...
Power Quality Improvement Using Grid Side Converter of Wind Energy Conversion System_计算机硬件及网络_IT/计算机_专业资料。Journal of Energy and Power ...
IEEE TRANSACTIONS ON ENERGY CONVERSION, VOL. 24,...models for predicting the power of a wind farm ...The SCADA system of every wind turbine collects ...
the wind power system used in this paper was ...series models the electrical grid [12], [13]....1. During the conversion of wind energy into ...
Design and control of a wind power station with...Power Electronics and Application 1997;2:723–8.... a variable speed wind energy conversion system. ...
Application of Wind Generation on Weak Networks Considering Potential System Limitations Due to_专业资料。Junlfnryn ornierg21)1—2 oraoEeg dwe gnen 028785 a...
It presents theoretical analysis, modelling and control of Wind Energy Conversion Systems (WECS) connected to an autonomous power system with hydrogen storage...
basic models of their equivalent power electronic...(WTs) The Wind Energy Conversion System includes ...IEEE Transactions on Industry Application MarcheApril...
Battery Energy Storage to Strengthen the Wind Generator in Integrated Power System_专业资料。JOURNAL OFELECTRoNISCINCEAND C E TECHNOLOG VOL.,9No.1MARCH 01...
The strongest observed winds on a planet in our solar system occur on ...Wind power is the conversion of wind energy into a useful form of energy...
热门文档