文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 电子/电路 > Study on the Permanent Magnet Demagnetization Fault in Permanent Magnet Synchronous Machines
侵权投诉

Study on the Permanent Magnet Demagnetization Fault in Permanent Magnet Synchronous Machines

永磁同步电机永磁体抗去磁能力的研究

faults are quickly detected. Appropriate tracing of the misalignments, rotor ovality, bearing attrition, axial bending, variation of the current value in each phase of the machine malformation in the rotor magnetic core and magnetic

resonance at critical speeds [12]. In the case of dynamic enables fault detection between turns.

eccentricity, the longitudinal change of the air gap while the

B. Short circuit fault in the DC barrage. rotor turns transforms the stator winding inductances and the A short circuit at the exit of the DC bar or a short circuit resultant flow connections into frequency components of the fault in the DC condenser might appear. If so, the DC bar’s rotation frequency and its multiples. voltage decreases rapidly, followed by a long transient of the It is worth remarking that, in the case of speed increases in power supply, as the supply is short-circuited by the the event of dynamic eccentricity, the significance of the converter. Hence, the detection voltage drop in the DC bars fault harmonics in the stator current increases and the is enough to diagnose and report the fault. amplitude of these harmonics in the electromagnetic torque

diminishes [13].

C. Bearing Fault.

Under normal conditions, and after some time working, the F. Defects in the Permanent Magnet for PMSM parts might present fatigue, which increases the noise level Breakings or fissures in the permanent magnet cause the and the vibrations [6-7]. machine’s constant flow to decrease, create noise and It has been proved that, in induction machines, these vibrations due to the magnetic imbalance, and may lead to variations appear in the stator current with certain rotor disintegration in the case of high speeds. frequencies: rotation frequency function, number of poles, The highest demagnetization risk appears at low inside and outside diameter of the bearing ball, and contact temperature, when the residuary flow density is elevated and angle of the ball with its support or jacket [7]. the coercive power is low. That is the case in a machine with Some of the approaches for online detection of these faults high short circuit current, in which the magnet cannot resist use neuronal networks, such as those in [10]. Other solutions the demagnetizing volt-amperes. [11] propose a frequency – statistical adaptive time method, Previous studies [12-13] show that rotor faults appear in focused on the detection of bearing faults and in induction the harmonics which are induced into the stator current, at a machine cages. frequency equal to the rotating speed and in its multiples. These proposals require a perfect classification of faults. The present article introduces the analysis of the stator and Besides, the detection procedure requires extensive training zero sequence current harmonics or a PMSM motor which to achieve an accurate diagnosis. has partially been demagnetized and which operates at

nominal torque and different speeds.

D. Static Eccentricity.

II. VECTOR CONTROL OF THE PMSM. Eccentricities are normally permitted in the air gap due to

manufacturing tolerances. However, when the latter are The permanent magnet PMSM motor powered by a sufficiently elevated, the static and dynamic eccentricities triphasic sinusoidal supply induces electromotive sinusoidal produced are higher than expected and unbalanced radial force in the air gap, which produces a constant torque [3-4]. powers appear, which at the same time carry rotor shaft Taking into account the following assumptions, and applying inclinations, bearing fissures, etc. If these are not detected, the Park transform, we can obtain the model in the axes qd0 their effects can accumulate and cause greater damage to the produced by the equations (1) and (2): machine, and this can even lead to contact between the stator

The saturation effects are negligible. and the rotor [12].

The EMF induction is sinusoidal and balanced in the

In case of a fault due to static and dynamic eccentricity,

three phase system. the most important fault frequencies in the stator current

analysis are the synchronic frequency divided by the pole The losses due to parasitic and hysteresis currents are

negligible. pair and the multiples of the frequency, especially the

multiples 1, 3, 5 and 7 of the rotor frequency. There is no dynamic field current

Static eccentricity induces several air gaps in different

rotor points, which makes inductances in the three phases With these assumptions, the stator d, q equations of the different. These differences become clear in the direct, PMSM in the rotor reference frame are: inverse or zero sequence components of the current or

magnetic flow of the air gap. (1)E. Dynamic Eccentricity.

Dynamic eccentricity might appear following an

inclination of the rotor shaft, a misuse of the bearings or

[v]=[R][i]+ t[λ]+ωλ

qdo

qdo

qdo

qd

[v]=[v[i]=[i

Tqdo

Tqdo

q

q

vd

id

io

]

vo

]

上一页第2页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email