表面活性剂在油田的应用
Sub-phase controlled wetting of porous silica films
Table 1. Surface and interfacial tensions of various liquids used in the present study. All the surfactant solutions were prepared in aqueous 1 M NH4OH. Liquid surface tension Liquid (mN/m)a
641
Sub-phase/heptane interfacial tension (mN/m)a
Water 69 (± 1) 49 (± 2) Heptane 21 (± 2) – 0 1 CMC CTAB 53 (± 1) 25 (± 1) 1 CMC CTAB 34 (± 1) 2 (± 1) 5 CMC CTAB 24 (± 2) 1 (± 1) 0 1 CMC SDS 47 (± 1) 30 (± 1) 1 CMC SDS 34 (± 1) 5 (± 2) 5 CMC SDS 25 (± 2) 3 (± 2)
a
Figures in the bracket indicate error estimated from 3 measurements
Table 2. Equilibrium contact angle of three phase contact line of heptane–water–silica film after diffusion of surfac-tant in to the drop from the sub-phase. The initial contact angle (θo) was ~ 140° (± 5). Type and approx. concentration
of the surfactant in the 1 M NH4OH sub-phase
Equilibrium contact anglea 47o (± 4) 16o (± 5) 128o (± 3) 110o (± 5)
Time interval for the
equilibrated contact angle (min)
25 25 600 600
Rate of change of contact angle degrees/min (approx.)
4 6 0 025 0 05
1 CMC CTAB 5 CMC CTAB 1CMC SDS 5 CMC SDS
a
Figures in the bracket indicate error estimated from 3 independent measurements
exchanged with pure water. Figure 3c shows the water droplet in equilibrium, after the surfactant diffusion from water drop back to the sub-phase was com-plete. This process took 2 h and the contact angle increased to 90°, indicating the process is partially reversible. This reverse diffusion of surfactant was slower, with the rate of change of contact angle be-ing 0 75 deg/min. This may be due to the smaller concentration gradient between a 15 μl CTAB rich droplet and the large pool (~50 ml) of pure water, in this case, as compared to the pure water drop-CTAB sub-phase system discussed earlier. However, for a fresh drop of 1 CMC CTAB solution placed on the silica film with pure water as sub-phase, contact angle increased from 10° to 140° in 80 min (rate of change of contact angle being ~ 1 5 deg/min). This indicates that the surfactant adsorbs on the silica film. When the sub-phase is rich in surfactant, it adsorbs on the silica film as well as diffuses to the drop. After re-placing the surfactant rich sub-phase with pure water, the contact angle increases slowly, which means the surfactant concentration in the drop and on the film surface is almost similar and the surfactant desorbs from the film surface very slowly leading to a slow diffusion of surfactant away from the drop into the
sub-phase. However, when there was no surfactant adsorbed initially on the film, the diffusion of sur-factant from the drop to the film and the sub-phase are very rapid.
To study the effect of surfactant head group charge on its diffusion through the silica film, contact angle of water droplet was also measured as a function of anionic surfactant sodium dodecyl sulfate’s (SDS) concentration in the sub-phase. Although the inter-facial tension for heptane-surfactant solution is almost independent of the type of surfactant, the change in contact angle was very slow in case of a sub-phase with SDS. As seen from table 2, the rate of change of contact angle for SDS was slower by two orders of magnitude, compared with a solution with similar CTAB concentration. To study SDS diffusion in the reverse direction, a drop containing SDS solution was placed on the silica film with water as sub-phase. For a droplet with 1 CMC SDS, the rate of change of contact angle was very slow (~ 0 03 deg/min), as the contact angle increased from 30° to only 32° in 60 min.
Both CTAB and SDS have similar size of mole-cules and the radius of micelles (~ 3 nm) formed by these surfactants (above CMC) is much smaller than
Synergism in the wetting properties of ternary surfactant mixtures 隐藏>> Synergism in the Wetting Properties of Ternary Surfactant Mixtures Hermann G. Hauth...
ed Surfactants and Wetting: IV. Spreading Behaviour of Trisiloxane Surfactants...lm 0.3 nm thick.5 Fast adsorption of surfactant molecules onto the sub...
ed Surfactants and Wetting: IV. Spreading Behaviour of Trisiloxane Surfactants...lm 0.3 nm thick.5 Fast adsorption of surfactant molecules onto the sub...
热门文档