表面活性剂在油田的应用
638 Manish M Kulkarni et al
interface. Here, we investigate the barrier properties of the interfacially grown, mesoporous silica films to the movement of oil and water. Clearly, the barrier offered by the mesoporous film depends on its selec-tive wetting by water surrounded by oil. We ex-ploited the porous nature of the silica film to change its wetting properties by diffusion of surfactants across the pores of the film. The advantage of our method is that the solid surface energy need not be modified to change the contact angle. Instead, the down on the oil-side surface of the silica film. The
droplet was photographed at fixed time intervals of 2 min up to an overall duration of 10 h with a hori-zontal optical microscope at 100 X magnification coupled with a CCD camera capable of capturing images at 25 fps. The contact angle (θ) of the water droplet was calculated by measuring the height (h) and length of the contact line (d) of the droplet. These three parameters are related by the following equation:16
interfacial energy of the drop with the surrounding bulk liquid is tuned such that a non-wetting drop of water completely wets the porous solid film. More-over, this transition is partially reversible. Kumar 11et al have investigated the wetting dynamics of liquid over a porous media and identified various stages of spreading based on the importance of governing forces. However, in our work, the porosity of the solid film plays an important role in a different con-text in that the change in the interfacial energy of the two liquids is achieved by diffusion of a surfac-tant to/from the water sub-phase across a solid sub-strate. This method of controlling the interfacial tension may have potential applications in the re-lated areas of chemical reactors, microfluidic devices such as interfacial tensiometer12,1314,15 and oil reco-very.
2. Materials and methods
A silica precursor, like, tetraethoxysilane (TEOS, puriss grade, Fluka chemicals) was dissolved in hep-tane (HPLC grade, Loba chemicals). This solution was then slowly poured onto a water–ammonia mix-ture in a way such that the oil–water interface thus formed was free from any bubbles or drops. Typi-cally the molar ratio of TEOS: heptane was kept constant at 1 : 7 5, and the aqueous phase had 1 M NHaqueous phase as the sub-phase. Silica film forma-4OH. For the rest of the paper, we refer to the tion at the heptane–water interface started immedi-ately. The thickness of the film could be controlled by changing the heptane/TEOS molar ratio and the time allowed for growth of the film. Film growth was stopped by removing the top oil (TEOS–heptane) phase, once a silica film of desired thickness was formed. Pure heptane was then poured slowly again
with minimum disturbance on the film for further contact angle measurements. An approximately 5 μl water droplet was then in-troduced in the oil phase, which subsequently settled θ=2tan 1 2h
d
. (1)
Surface tension of a liquid and liquid–liquid interfa-cial tension were measured with a tensiometer (Fisher Surface Tensiomat, USA) using a Pt-ring probe. Contact angle and surface tension measurements were repeated thrice to estimate the measurement error.
3. Results and discussion
It is well known that hydrolysis and polycondensa-tion of alkoxysilanes in presence of water leads to the formation of silica.17 However, synthesis of silica films at interfaces is not much explored, apart from the studies of Faget 18et al10 and Bandyopadhyaya et al on mesoporous silica film synthesis at oil–water interface. Recently, we reported synthesis of methyl-trimethoxysilane based silica films at the oil–water interface.19 It was observed that after drying, these films exhibit Janus hydrophobic–hydrophilic proper-ties across the oil and water side surfaces, respec-tively. However, in the present study, we use tetra-exthoxysilane (TEOS) as the silica precursor and prepared the silica films both without and with ionic surfactants (SDS and CTAB). In presence of a cata-

Figure 1. Schematic diagram of experimental set-up for growing silica film at the macroscopic heptane–water interface.
Synergism in the wetting properties of ternary surfactant mixtures 隐藏>> Synergism in the Wetting Properties of Ternary Surfactant Mixtures Hermann G. Hauth...
ed Surfactants and Wetting: IV. Spreading Behaviour of Trisiloxane Surfactants...lm 0.3 nm thick.5 Fast adsorption of surfactant molecules onto the sub...
ed Surfactants and Wetting: IV. Spreading Behaviour of Trisiloxane Surfactants...lm 0.3 nm thick.5 Fast adsorption of surfactant molecules onto the sub...
热门文档