Particle dynamics in aeolian saltation has been studied in a boundary layer wind tunnel above beds composed of quartz grains having diameters of either 254 μm or 320 μm. The cross section of the tunnel is 600 mm × 900 mm and its thick boundary layer all
have observations very close to the bed (5 mm above the bed). It should be noted that the
estimated mean values of the vertical component of the launch velocity and of the launch angle do not vary much with the friction speed. This is in accordance with findings in Namikas (2003) and gives support to the arguments in Sørensen (2004) that the empirical parameters in the transport rate formula in that paper do not depend on the friction speed.
Particle diameter
Dp=242 µm
u*
Height 0.274 0.394 0.558 0.685 (m) (m/s) (m/s) (m/s) (m/s)
1.63 2.14 2.41 0.005 - 1.079 1.562 1.607
2.02 2.32 2.61 2.85 0.01 1.005 1.079 1.176 1.192
2.55 2.96 3.39 3.70 0.02 0.973 0.997 1.053 1.003
3.42 3.88 4.22 0.03 - 1.009 0.997 0.929
3.19 3.81 4.39 4.84 0.04 0.967 1.000 0.883 0.931
4.04 4.77 5.70 6.17 0.08 0.988 0.977 0.973 0.994 Particle diameter Dp=320 µm u* 0.27 0.47 0.74 (m/s) (m/s) (m/s) 1.93 1.89 2.07 1.532 1.312 1.418 2.23 2.26 2.49 0.978 1.209 1.127 2.82 2.88 3.18 1.037 1.059 0.994 - 3.55 0.997 4.52 0.954 - 3.76 0.957 4.75 0.921 - 4.20 0.871 5.50 0.841
Table 2. Model predictions of the mean horizontal grain speed (Vgp) in m/s and ratios
between predicted and measured mean particle speeds (Vgp/Vg).
With the parameters given above the calculated mean horizontal grain speed for the two particle sizes are given in Table 2, together with ratios between predicted and measured speeds. Overall there is reasonable agreement between the values. However, below 10 mm height the model systematically predicts higher grain speed than the measured speeds, while at the highest levels the model predictions are systematically lower than measured values. Possibly this is due to
deficiencies in the model, but it may also result from measurements error in the grain laden layer close to the bed.
Initially, grain speeds were also predicted assuming that the vertical lift-off speed of the grains is exponentially distributed (gamma distribution with shape parameter one). For this
distribution values the tendency for overestimation at low levels and overestimation at high levels is the same, but the numerical differences between measured and estimated values were found to be larger, i.e. about 20-70 % underestimation at the lowest levels and 10 % overestimation at the highest levels.
The vertical variation of particle speed and flux density in aeolian saltation measurement Particle dynamics in aeolian saltation has been studied in a ...
In addition, it was found that when taking the Magnus force into account,...(2008), Vertical variation of particle speed and flux density in aeolian ...
In addition, it was found that when taking the Magnus force into account,...(2008), Vertical variation of particle speed and flux density in aeolian ...
热门文档