Particle dynamics in aeolian saltation has been studied in a boundary layer wind tunnel above beds composed of quartz grains having diameters of either 254 μm or 320 μm. The cross section of the tunnel is 600 mm × 900 mm and its thick boundary layer all
air) and the parameters of the gamma distribution and the normal distribution that model the probability distribution of the launch velocity, were chosen so that the best possible fit was obtained to the observed grain fluxes and to the observed probability distributions of the
horizontal velocity component of the grains. Specifically, the distance between measured and theoretical values of the mean and standard deviation of the horizontal grain velocity distribution and the distance between observed and model grain fluxes were minimized. It turned out that the best fit was in almost all cases obtained for a value of the shape parameter of the gamma
distribution close to three. Therefore the shape parameter was in all cases taken to equal three. This differs from the results of Anderson & Hallet (1986) and Namikas (2003) who, using only flux data, obtained the best fit with the shape parameter equal to one (the exponential
distribution). With the shape parameter fixed, the general picture was that the magnitude of the mean value of the vertical component of the launch velocity was mainly determined by the
vertical variation of the grain flux, the mean launch angle was then determined essentially by the mean values of the horizontal grain speeds, and the variance of the launch angle by the variances of the horizontal grain speeds. The observed variances of the horizontal grain speeds appear to have a considerable random variation, and it is not unlikely that the actual variances vary much less with height. It was therefore not attempted to fit in detail the vertical variation of the observed variances. The quantity phi was chosen so that the sum of the observed fluxes was equal to the sum of the model fluxes. The parameters which produced the best fit to the observed grain speeds and grain flux densities are given in Table 1.
Dp=242 µm Friction speed Mean vertical Mean vertical Variance on Number (m/s) Of grains launch speed (m/s) launch angle launch angle
0.274 16632 0.36 25 89
0.394 46222 0.36 20 53
0.558 17265 0.38 19 35
0.685 31978 0.38 16 30
0.27
0.47
0.74 1708 12202 20826 0.40 0.37 0.38 Dp=320 µm 19 20 20 25 50 65
Table 1. Model parameters
The estimated values of the mean vertical launch velocity are consistently close to 0.38 m/s in good accordance with the values found in Rasmussen & Sørensen (2005) and with those found by White & Schulz (1977) and Nalpanis (1985) using high speed film. Sørensen (1985) and
Namikas (2003) found mean vertical lift-off speeds that were somewhat larger. The mean launch angles are smaller than those found in other studies. White & Schulz (1977) found a mean angle of 50 degrees, Nalpanis (1985) reported mean angles in the range 34 – 41 degrees, and Sørensen (1985) in the range 43 – 46 degrees. Willetts & Rice (1985) found the range 21 – 33 degrees for ricochet angles and 52 – 54 for ejected grains. Our smaller values might be due to the fact that we
The vertical variation of particle speed and flux density in aeolian saltation measurement Particle dynamics in aeolian saltation has been studied in a ...
In addition, it was found that when taking the Magnus force into account,...(2008), Vertical variation of particle speed and flux density in aeolian ...
In addition, it was found that when taking the Magnus force into account,...(2008), Vertical variation of particle speed and flux density in aeolian ...
热门文档