文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > The vertical variation of particle speed and flux density in aeolian saltation measurement
侵权投诉

The vertical variation of particle speed and flux density in aeolian saltation measurement

Particle dynamics in aeolian saltation has been studied in a boundary layer wind tunnel above beds composed of quartz grains having diameters of either 254 μm or 320 μm. The cross section of the tunnel is 600 mm × 900 mm and its thick boundary layer all

where σ is the density of the grains, and µ denotes the viscosity of air. The equations of motion were solved numerically by keeping the wind speed and H constant in small height intervals of 1 mm. This corresponds to using the explicit trajectory model in Sørensen (1991) in each of these small height intervals and is a very quick way of solving the equations.

(0),y (0)) is random. It is assumed that (x(0),y(0))= (0,0) and that the launch velocity (x

The following rather simple assumptions are made about the probability distribution of the

(0) is taken to be gamma distributed. This launch velocity vector. The vertical component y

distribution has the probability density function

wα 1e wβ

p(w)=,w>0 Γ(α)βα

and its mean value is αβ. The parameter α is called the shape parameter because it determines the general shape of p(v). The probability distribution of the vertical lift-off speed was also modeled by a gamma distribution by Anderson & Hallet (19896) and Namikas (2003). In

(0) was taken to be exponential distributed, which is a Rasmussen & Sørensen (2005) y

particular case of the gamma distribution with α=1. The generalization to the gamma

distribution was made because it gives a much better fit to the observed vertical variation of the grain flux. The launch angle (relative to a vector in the flow direction) is assumed to be normal

(0). The angle is however restricted to be positive and smaller distributed and independent ofy

than 150°.

For a given choice of the gamma distribution and the normal distribution that model the launch velocity of the grains, we can at any given height calculate the distribution of the

horizontal component of the grain velocity and the grain flux. For a given launch velocity, we can obviously calculate the horizontal component of the grain velocity at a given height. By making a fine discretization of the launch velocity distribution and calculating a grain trajectory for each velocity vector in the discretization, we obtain a very accurate approximation to the probability distribution of the horizontal component of the grain velocity at the given height. A grain with a particular launch velocity makes two contributions to this distribution: one on the way up and one on the way down, but only if the top of the grain trajectory is above the given height. The mass of grains that per time unit move through a plane surface with unit width, perpendicular to the mean wind direction and going from height y1 to height y2 is

φ (y1,y2)

where φ is the mass flux of grains from the sand bed into the air, and (y1,y2) is the horizontal displacement of a grain while its altitude is between the heights y1 and y2 on its way up and down. This quantity can easily be calculated using the numerical model. The bar indicates mean value with respect to the distribution of the launch velocity. In particular, the total transport rate is given by φ, where is the mean jump length of a grain. For details about these calculations see Jensen & Sørensen (1982) and Sørensen (1985).

上一页第5页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email