Particle dynamics in aeolian saltation has been studied in a boundary layer wind tunnel above beds composed of quartz grains having diameters of either 254 μm or 320 μm. The cross section of the tunnel is 600 mm × 900 mm and its thick boundary layer all
findings, either numerical models (e.g. Sørensen 1985, Anderson & Hallet 1986, Jensen & Sørensen 1986, Anderson and Haff 1988, 1991, Werner 1990, McEwan & Willetts 1991, 1993, Shao & Li 1999, Spies & McEwan 2000, Spies el al. 2000) or analytical models that result in explicit formulae (e.g. Owen 1964, 1980; Sørensen 1991, 2004; Sauermann et al. 2001).
To verify the assumptions made in such mathematical models, direct observations are needed of fluid shear stress and particle behavior in the saltation layer, including the splash process when a grain impacts on the bed, rebounds and ejects other grains. However, the momentum transfer and the splash process take place in a very shallow layer at the air-bed
interface with large grain concentration and velocity gradients where it is very difficult to make reliable measurements. Therefore existing experimental data are not made close to the surface or are made under somewhat artificial conditions. The splash process has been studied by computer simulations (e.g. Werner & Haff 1988; Anderson & Haff 1991) and experimentally in wind tunnel experiments with a controlled very small transport rate (e.g. Willetts & Rice, 1985, 1989; Rice et al. 1996) or by propelling single metal particles (Mitha et al. 1986) or sand grains
(Werner, 1990) into a static bed of similar particles. Particle trajectories have been studied using high speed photography (e.g. White and Schultz 1977; Nalpanis 1985) or stroboscope (Mitha et al. 1986) that enable data on the variation of grain speed with height, but unfortunately only for small particle concentrations. In recent years, laser based methods (e.g. Phase Doppler Analyzers, PDA and laser Doppler) have become available for measuring directly particle speed in the saltation layer (Dong et al. 2002; Rasmussen & Sørensen 2005). Measurement of particle speed using optic Doppler sensors can potentially be used at higher particle concentrations nearer to the bed, and despite the fact that misinterpretation of such data is possible (Rasmussen & Sørensen, 2005), they may potentially give precise values for the variation of grain speed with height (Rasmussen 2002; Dong et al. 2002).
The objective of the present study is to gain further insight in the saltation process by combining an experimental study and theoretical modeling. Data on air and particle speed and flux density are obtained at a number of heights above the bed using laser-Doppler technology, and the numerical model of Jensen & Sørensen (1986) further developed and shown to predict the observations well. The model results are also compared to results in Rasmussen and Sørensen (2005) obtained using an approximate analytical model. .
Firstly a description of the experimental setup is given followed by a brief explanation of the mathematical model. Then data on the vertical variation of horizontal grain speed and grain flux density above beds of quarts grains having either diameter Dp=254 µm or Dp=320 µm are presented. For a range of friction speeds observed profiles of wind velocity, grain velocity, and grain flux density are compared to each other, to findings by other researchers, and to predictions made using the mathematical model.
2 INSTRUMENTS AND METHODS
The general set-up of the wind tunnel at Aarhus University is depicted in Figure 1. The working section of the tunnel is 15 m long and has a rectangular cross section of width W=0.60 m and height H=0.90 m. The tunnel is constructed from 22 mm plywood, with large glass panes inserted in the front and at three positions in the rear side of the working section. All front glass panes can
The vertical variation of particle speed and flux density in aeolian saltation measurement Particle dynamics in aeolian saltation has been studied in a ...
In addition, it was found that when taking the Magnus force into account,...(2008), Vertical variation of particle speed and flux density in aeolian ...
In addition, it was found that when taking the Magnus force into account,...(2008), Vertical variation of particle speed and flux density in aeolian ...
热门文档