文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > The vertical variation of particle speed and flux density in aeolian saltation measurement
侵权投诉

The vertical variation of particle speed and flux density in aeolian saltation measurement

Particle dynamics in aeolian saltation has been studied in a boundary layer wind tunnel above beds composed of quartz grains having diameters of either 254 μm or 320 μm. The cross section of the tunnel is 600 mm × 900 mm and its thick boundary layer all

The vertical variation of particle speed and flux density in aeolian

saltation: measurement and modeling

1Keld R. Rasmussen1 and Michael Sørensen2 Department of Earth Sciences, University of Aarhus, Block 520, Ny Munkegade, DK-8000 Aarhus C, Denmark. 2 Department of Applied Mathematics and Statistics, Universitetsparken 5, DK-2100 Copenhagen, Denmark. ABSTRACT

Particle dynamics in aeolian saltation has been studied in a boundary layer wind tunnel above beds composed of quartz grains having diameters of either 254 µm or 320 µm. The cross section of the tunnel is 600 mm × 900 mm and its thick boundary layer allows precise estimation of the fluid friction speed. Saltation is modelled using a numerical saltation model and predicted grain speeds agree fairly well with experimental results obtained from laser-Doppler

anemometry. At 80 mm height the ratio between air speed and grain speed is about 1.1 and from there it increases towards the bed so that at 5 mm it is about 2.0. All grain speed profiles converge towards a common value of about 1 m/s at 2-3 mm height. Flux density profiles, measured with a laser-Doppler appear to be similar to most other density profiles measured with vertical array compartment traps, i.e. two exponential segments will fit data between heights from a few mm to 100-200 mm. The experimental flux density profiles are found to agree well with model predictions. Generally validation rates are low from 30-50 % except at the highest level of 80 mm where they approach 80 %. When flux density profiles based on the validated data are used to estimate the total mass transport rate results are in fair agreement with measured transport rates except for conditions near threshold where as much as 50 % difference is observed.

Keywords: Aeolian dynamics, saltation model, grain speed, flux density, mass transport, wind tunnel.

1 INTRODUCTION

When the wind blowing over an immobile bed of cohesionless grains becomes sufficiently strong, grains are set in motion. Grains in the size range of 100-600 µm are hopping or dancing over the surface in saltation, which is the primary mode of movement (Bagnold 1941). Saltation is an important link by which momentum is transmitted from the air to the bed through grain impact.

Several approaches have been taken to study the saltation process. In a large number of studies grain fluxes and their horizontal variation and wind profiles within the saltation layer have been measured in wind tunnels or in the field (e.g. Horikawa & Shen 1960; Williams 1964; Jensen et al 1984; Rasmussen & Mikkelsen 1991; White and Mounla 1991; Rasmussen et al. 1996; McKenna-Neuman & Maljaars 1997; Iversen & Rasmussen 1999; Namikas 2003; Liu & Dong 2004). Several mathematical models have been proposed to explain such empirical

第1页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email