Super-Nyquist-WDM
Measured BERs of the single-channel duobinary-pulse-shaped signals without and with MLSE are plotted as a function of optical signal to noise ratio (OSNR) in the back-to-back configuration by dots and closed triangles in Fig. 3(b). Open circles and open triangles are results of the single-channel conventional Nyquist-pulse-shaped signals without and with MLSE, respectively. A dashed line indicates the theoretical curve of Nyquist-pulse-shaped DP-QPSK signals. Although we observed the penalty of >3 dB in the case of the duobinary-pulse shaped signal without MLSE compared with the conventional Nyquist-pulse-shaped signal at the BER of 10 2, the penalty was improved by 1 ~2 dB by using MLSE. On contrary, we cannot find any improvement by MLSE in the case of the Nyquist-pulse-shaped signals. Consequently, the penalty of the duobinary-pulse-shaped signals with MLSE is about 2 dB at the BER of 10 2 compared with Nyquist-pulse-shaped signals.
Figure 3(c) shows measured BERs of dual-channel duobinary-pulse-shaped signals. Dots, open triangles, and closed triangles indicate results when the δf was set to be 18 GHz, 15 GHz, or 12 GHz, respectively. Open circles are results in the single-channel (SC) case. We observed that the penalty due to crosstalk became larger with the smaller frequency spacing. The penalty at δf = 15 GHz was suppressed to be 1 dB, although that at 12-GHz spacing was significantly large. It is shown that the penalty can be suppressed as far as B/δf ≤ 1.20.
When the frequency spacing was fixed to be 15 GHz, we compared duobinary-pulse-shaped DP-QPSK signals with conventional Nyquist-pulse-shaped signals. Dots and closed triangles in Fig. 3(d) indicate measured BERs of the single-channel and dual-channel duobinary-pulse-shaped signals, respectively. Open circles and open triangles are results of Nyquist-pulse-shaped signals in the single-channel and dual-channel cases, respectively. We can see that even though the performance of the duobinary-pulse shaping is about 2 dB worse than that of the conventional Nyquist-pulse shaping in the single channel case, it was significantly better than that of Nyquist-pulse shaping in the 15-GHz spaced WDM case at the BER of 10 2. These results suggest that the duobinary-pulse shaping is effective to suppress the crosstalk between super-Nyquist-WDM channels.
4. Super-Nyquist-WDM transmission experiment over seven-core fibers with full-C-band seven-core EDFAs
Next, we evaluated the transmission performance of the super-Nyquist-WDM DP-QPSK signals with duobinary-pulse shaping. Here, we multiplexed 201-channel 30-Gbaud duobinary-pulse-shaped DP-QPSK signals with frequency spacing of 25 GHz. This corresponds to B/δf = 1.2, and this condition satisfies that duobinary-pulse shaping can efficiently suppress the penalty due to the linear crosstalk as mentioned in Section 3. 4.1 Experimental setup
Figure 4 shows the experimental setup. The transmitter consisted of a three-rail configuration as reported in [7]. The two rails were used for eight even and eight odd channels. The even and odd channels were generated by multiplexing eight ECLs arranged with frequency spacing of 50 GHz, and they were then independently modulated by two IQMs driven by 30-Gbaud electrical duobinary-pulse-shaped binary signals generated from an AWG at sampling rate of 50 Gsample/s. After the modulation, we equalized the power per channel of WDM signals by a polarization-maintained wavelength selective switch (WSS) based on a liquid crystal on silicon (LCOS). The third rail was a loading rail for generating 201 WDM channels in order to maintain not only an OSNR but also nonlinear effects. A total of 101 lasers were combined onto a 50-GHz frequency grid. After they were modulated by a LiNbO3 Mach-Zehnder modulator (MZM) driven by 12.5-GHz electrical clock so that the carrier components were suppressed, we obtained 201 CW tones with a 25-GHz spacing ranging from 191.2625 THz to 196.2875 THz. All 201 channels were then passed through an IQM driven in the same manner as the modulators in other two rails. In the experiment, we disabled 16 consecutive channels on the loading rail, and the measured 16 channels from other two rails were tuned to the corresponding frequencies.
#200695 - $15.00 USD(C) 2014 OSAReceived 7 Nov 2013; revised 4 Jan 2014; accepted 7 Jan 2014; published 13 Jan 201427 January 2014 | Vol. 22, No. 2 | DOI:10.1364/OE.22.001220 | OPTICS EXPRESS 1224
AN ERROR-RESILIENT H.263+ CODING SCHEME FOR VIDEO TRANSMISSION OVER WIRELESS NETWORKS_专业资料。维普资讯 http://www.cqvip.com V13No6b. ,2 JOUR N人L0...
Experimental Research on Wave Transmission over Submerged Rubble-Mound Breakwaters_专业资料。Chn enEnneig.Vo.2,No.iaOca giern124,P55—54P.78 ⑧20 ...
Packetisation Strategies for Enhanced Video Transmission over Wireless LANs Pierre Ferr? 1 , Angela Doufexi1, Andrew Nix1,2 , David Bull1,2 e ...
LOW-LATENCY VIDEO TRANSMISSION OVER LOSSY PACKET NETWORKS USING RATE-DISTORTION OPTIMIZED REFERENCE PICTURE SELECTION Yi J. Liang, Markus Flierl and Bernd ...
Cross-Layer Optimization for Video Summary Transmission over Wireless Networks Abstract — Video summarization has gained increased popularity in the emerging ...
ENGINEERING AND TECHNOLOGY VOLUME 16 NOVEMBER 2006 ISSN 1307-6884 Layered Multiple Description Coding For Robust Video Transmission Over Wireless Ad-Hoc ...
COMPARISON OF RATE ALLOCATION STRATEGIES FOR H.264 VIDEO TRANSMISSION OVER WIRELESS LOSSY C In this paper we study the problem of transmitting coded video...
Standard-Compliant Enhancements of JVT Coded Video for Transmission over Fixed and Wireless IP Thomas Stockhammer Institute for Communications Engineering (LNT)...
Video quality based link adaptation for low latency video transmission over WLANs_专业资料。[1]Ci,S.,Sharif,H.,2002.A Variable Data Rate Scheme to ...
2, 189–206, 2008 PROPOSED MAC PROTOCOL VERSUS IEEE 802.15.3A FOR MULTIMEDIA TRANSMISSION OVER UWB NETWORKS N. El-Fishawy, M. Shokair, and W. Saad...
热门文档