文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > 2014-OE-Super-Nyquist-WDM transmission over
侵权投诉

2014-OE-Super-Nyquist-WDM transmission over

Super-Nyquist-WDM

sensitivity in principle. However, this penalty can be ideally compensated by MLSE with one memory. Figure 2(a) indicates DSP in the receiver. Firstly, two streams corresponding to two polarizations of received optical complex amplitudes are dispersion-compensated (DC) and Nyquist-filtered in the frequency domain. After that, the polarization demultiplexing and linear equalization are done by an adaptive finite impulse response (FIR) filter with the butterfly configuration. The tap coefficients are updated based on the least-mean-square (LMS) algorithm. Using MLSE, the symbols are decoded from the real and imaginary parts of the equalized samples after the adaptive filter. Figure 2(b) shows the trellis for the duobinary signals. Each node at t = k has two incoming paths and two corresponding metrics. One out of two incoming paths is selected as the most probable, based on the metric calculated by the decision error of the path with the metric of the nodes at t = k – 1.

So far, there have been reports on super-Nyquist-WDM transmission using optical filters as duobinary-pulse shaping filters [8,9]. Here, we directly generated duobinary-pulse-shaped DP-QPSK signals using DAC following DSP and the optical IQ modulation. This has advantages of higher accuracy and higher resolution compared with pulse shaping in the optical domain.

3. Crosstalk characteristics of dual-channel DP-QPSK signals with duobinary-pulse shaping

First, we experimentally evaluated the crosstalk characteristics of dual-channel duobinary-pulse-shaped DP-QPSK signals. Here, the baudrate B was set to 18 Gbaud relatively lower in order to minimize the impact of bandwidth limitation by optical and electrical devices used in the experiments. Two continuous wave (CW) lights generated from external-cavity lasers (ECLs) with different wavelengths were independently modulated by two LiNbO3 optical IQ modulators (IQMs). The IQMs were driven by 18-Gbaud electrical signals with square-root duobinalry-pulse shaping which were generated by an arbitrary waveform generator (AWG) with a 24-Gsample/s DAC after DSP as shown in Fig. 1(a). After the polarization multiplexing, we obtained dual-channel duobinary-pulse-shaped DP-QPSK signals. The spectral waveforms are shown in Fig. 3(a). The frequency spacing δf between dual channels was set to 18 GHz, 15 GHz, or 12 GHz, which corresponded to B/δf of 1.00, 1.20, or 1.50, respectively. Here, the frequency fluctuation of the lasers was below 10 MHz, and we adjusted precisely powers of dual channels to be equal. Using a digital coherent receiver, one of channels was detected.

Frequency

(a)

10-1BER

2014-OE-Super-Nyquist-WDM transmission over

2014-OE-Super-Nyquist-WDM transmission over

2014-OE-Super-Nyquist-WDM transmission over

2014-OE-Super-Nyquist-WDM transmission over

10-210-310-410-510-6

OSNR [dB](b)

OSNR [dB]

(c)

OSNR [dB](d)

Fig. 3. (a) Spectral arrangement of dual-channel duobinary-pulse-shaped DP-QPSK signals. (b) Measured BERs of single-channel (SC) duobinary-pulse-shaped signals with and without MLSE, (c) those of dual-channel duobinary-pulse-shaped signals with frequency spacing of 18GHz, 15GHz and 12GHz, and (d) those of dual-channel duobinary-pulse-shaped and Nyquist-pulse-shaped signals with frequency spacing of 15 GHz.

#200695 - $15.00 USD(C) 2014 OSAReceived 7 Nov 2013; revised 4 Jan 2014; accepted 7 Jan 2014; published 13 Jan 201427 January 2014 | Vol. 22, No. 2 | DOI:10.1364/OE.22.001220 | OPTICS EXPRESS 1223

上一页第4页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email