Super-Nyquist-WDM
controlled so that transfer function of the transmission channel with the receiver is the square-root duobinary-pulse shaping.
In a transmitter, the duobinary-pulse-shaped QPSK signals can be directly generated by optical IQ modulation with digital-analog converter (DAC) following digital signal processing (DSP). The DSP procedure is shown in Fig. 1(a). A binary data sequence is upsampled twice, and then the samples are square-root duobinary-pulse-shaped after the discrete Fourier transform (DFT). The samples after inverse DFT (IDFT) are resampled to sampling rate of DAC, and then they are sent to DAC. Figure 1(b) shows a model of duobinary-pulse shaping. An incoming sequence is summed with itself delayed by one symbol before the Nyquist-pulse shaping with the sinc function. The impulse response of the duobinary-pulse shaping hduo(t) is given as
hduo(t)=
1+δ(t 1/B)
sinc(πBt), (1)
2
where δ(t) is the delta function, and sinc(x) = sin(x)/x. The baudrate of the signal is B. This is indicated by a solid line in Fig. 1(c). It is composed of one-symbol-delayed two impulse responses with the Nyquist-pulse shaping as shown by dashed lines. The transfer function of the impulse response is given by the Fourier transformation of Eq. (1), and it is expressed as
1+exp( j2πf/B)
rect(f/B)=exp( jπf/B) cos(πf/B) rect(f/B),
2
(2)
Hduo(f)=
where rect(x) = 0 for |x| > 0.5 or 1 for |x| ≤0.5. Figure 1(d) shows |Hduo(f)|2 of the duobinary-pulse shaped signal. The signal bandwidth after the pulse shaping is reduced to be a half of baudrate at full width at half maximum. In DSP of our transmitter, the signal after DFT and Hduo(f

) are multiplexed in the frequency domain.
PRBS215-

1




(a)

Impulseresponse [a.u.]
Powerspectrum [a.u.]

Time [1/B/div]
(c)
Frequency [B/div]
(d)
(b)
Fig. 1. (a) DSP at transmitter, (b) model of duobinary-pulse shaping, (c) impulse response and

(d) power spectrum of duobinary-pulse shaping.
E

Ey
(a)
sksk(b)
B
Fig. 2. (a) DSP at receiver, (b) trellis for duobinary signals.
The binary sequence is converted to the three-level sequence after the duobinary-pulse shaping, resulting in the degradation of a receiver sensitivity. Receiving the duobinary-pulse-shaped signals by decision on the symbol-by-symbol basis gives a 2.1-dB loss in the receiver
#200695 - $15.00 USD(C) 2014 OSAReceived 7 Nov 2013; revised 4 Jan 2014; accepted 7 Jan 2014; published 13 Jan 201427 January 2014 | Vol. 22, No. 2 | DOI:10.1364/OE.22.001220 | OPTICS EXPRESS 1222
AN ERROR-RESILIENT H.263+ CODING SCHEME FOR VIDEO TRANSMISSION OVER WIRELESS NETWORKS_专业资料。维普资讯 http://www.cqvip.com V13No6b. ,2 JOUR N人L0...
Experimental Research on Wave Transmission over Submerged Rubble-Mound Breakwaters_专业资料。Chn enEnneig.Vo.2,No.iaOca giern124,P55—54P.78 ⑧20 ...
Packetisation Strategies for Enhanced Video Transmission over Wireless LANs Pierre Ferr? 1 , Angela Doufexi1, Andrew Nix1,2 , David Bull1,2 e ...
LOW-LATENCY VIDEO TRANSMISSION OVER LOSSY PACKET NETWORKS USING RATE-DISTORTION OPTIMIZED REFERENCE PICTURE SELECTION Yi J. Liang, Markus Flierl and Bernd ...
Cross-Layer Optimization for Video Summary Transmission over Wireless Networks Abstract — Video summarization has gained increased popularity in the emerging ...
ENGINEERING AND TECHNOLOGY VOLUME 16 NOVEMBER 2006 ISSN 1307-6884 Layered Multiple Description Coding For Robust Video Transmission Over Wireless Ad-Hoc ...
COMPARISON OF RATE ALLOCATION STRATEGIES FOR H.264 VIDEO TRANSMISSION OVER WIRELESS LOSSY C In this paper we study the problem of transmitting coded video...
Standard-Compliant Enhancements of JVT Coded Video for Transmission over Fixed and Wireless IP Thomas Stockhammer Institute for Communications Engineering (LNT)...
Video quality based link adaptation for low latency video transmission over WLANs_专业资料。[1]Ci,S.,Sharif,H.,2002.A Variable Data Rate Scheme to ...
2, 189–206, 2008 PROPOSED MAC PROTOCOL VERSUS IEEE 802.15.3A FOR MULTIMEDIA TRANSMISSION OVER UWB NETWORKS N. El-Fishawy, M. Shokair, and W. Saad...
热门文档