ALE3D模拟慢烤
formation of product gases occurred, but the simulations did not reach the user-specified ignition temperature of 427 C due to numerical convergence errors.
FIGURE 6. The slide surface gap, initially 1 mm, closes at a time of 68.5 hours, when the temperature is nearly uniform at 157 C.
FIGURE 7. The -HMX mass fraction field for the HE at a time of 67.9 hours (155.8 C) near the closing of the slide surface gap, initially 1mm. Scale: minimum (blue) 0.8630, maximum (red) 0.8797. Most of the -HMX has been transformed to -HMX.
Figures 8 and 9 show results from a model calculation for a 0.2 mm gap that uses slide surfaces to treat the gap interfaces. The problem is identical to that described above, except that the width of the gap has been reduced to 0.2 mm (see Figure 8). In this case, the gap closes in 50.8 hours, when only a small amount (~1%) of the HMX has undergone a phase change (see Figure 9). Thus, the
gap closure is almoste entirely due to thermal expansion.
Gap Material Model
We repeated the calculations with the 1.0 mm and 0.2 mm gaps by replacing the slide surfaces with our gap material model. The closing of the 1mm gap is illustrated in the material domain plots of Figures 10 and 11. They are similar to the slide surface results of Figures 4 and 5. A plot of hoop strain versus time is shown in Figure 12 for the slide surface and materials models approach for the closing of a 0.2 mm gap. For this case we obtained nearly identical results in terms of gap closing time and hoop strain on the steel. This result confirms the accuracy and effectiveness of the numerical methods.
FIGURE 8. Initial material domain for a 0.2 mm slide-surface gap.
FIGURE 9. The -HMX mass fraction field for the HE at a time of 50.8 hours (395 C) at the closing of the slide surface gap, initially 1 mm. Scale: minimum (blue) 0.01108, maximum (red)




0.01117.
热门文档