ALE3D模拟慢烤
method involves scaling the density of materials in order to decrease the effective speed of sound and therefore increase the stable Courant time step. This method applies in situations where there are many sound transient crossings during the simulation or where inertia effects are negligible. The appliciation of this methods leads to spurious oscillations in the motion of materials, and is numerically inefficient. This study is an effort in progress to develop the implicit method of integration to the point where cookoff problems can be accurately modeled.
Recently, several improvement have been made in the implicit hydrodynamics algorithm in ALE3D so that cookoff simulations can be performed. For the mechanical modeling of soft materials, the one-point quadrature used in numerical integration was replaced by an eight-point quadrature routine to improve numerical stability. This improvement is being applied for two numerical treatments of dynamic gaps between the explosive and case: mixed materials and slide surfaces. For the case of mixed materials the boundary between the explosive and air is not tracked with the mesh, resulting in some numerical zones with both explosive and air. In this approach, the normal component of the stress tensor is constant acros the material interface. This approach avoids mesh tracking difficulties and will work well with cases involving the flow of HE decomposition gases into the air gaps and through vents and leaks in the case to the outside environment. The disadvantages are that this approach does not currently accomodate thermal radiation across the gap and does not efficiently track the air/HE interface. Currently, work is focused on the development of a gap material for use with the implicit integration scheme for the momentum equation. A material for one-dimensional gap closing has been developed and will be extended to treat the case of more complex gap shapes.
The second method to treat gaps involves the method of slide surfaces in which air/gap interface is tracked with the mesh and there is no gap material. Although thermal radation across the gap is treated, it does not readily accomodate the flow of HE decomposition gases in the gap. Also there are questions about the practicality of using the method of slide surfaces in highly complex geometries. To date the eight-point quadrature and
gap closing algorithms have been installed for slide surfaces.
Each side of a slide surface is independently accelerated using interpolated physics quantities from the opposing side. Theacceleration of the nodes is decomposed into normal and tangential components. The normal component for each side is combined with the interpolated normal component from the opposite side to form a center-of-mass acceleration. When gaps close, the moment from the opposing sides are combined to form the center-of-mass momentum. Although slide surfaces can accurately follow surfaces and gap closure the method tends to be less numerically robust. In this study we present demonstration problems for slow cookoff using both of these methods to treat the gap between the high explosive and the heated metal.
Mesh and Boundary Conditions
The ALE3D computer code requires 3D meshes, and a wedge-shaped mesh is employed for the 2-D model of this study A small hole is present near the symmetryaxis to allow the use of hexahedral elements at all locations. In the base case, the tube cavity has 12 elements in the radial direction, which is increased by a factor of 2 in mesh refinement studies. Some of the elements have both HE and air, and standard mixing rules are employed to calculate the energy, heat capacity, thermal conductivity , shear modulus and equation of state. The mesh is smoothed using a combination of Lagrange and Eulerian algorithms. Nodes initially on the interface between the cavity and the steel remain on these boundaries while nodes interior to the cavity are advected through the flowing HE and air.
We use a one-dimensional axial symmetric ALE3D model. The computational domain is a 3D wedge, cylindrical section with symmetry boundary conditions on the sides of the wedge (see Figure 1) with 0.2 or 1 mm gap between the high explosive and the steel vessel. Slip conditions with no material or energy flow are applied at the z-planes bounding the domain. It is important to note that these z-plane conditions restrict expansion of the materials in the z-direction only. Since the experimental vessel expands in all three directions, the 1D model expansions are approximately 50%
热门文档