ALE3D模拟慢烤
C D r3 = Z3exp( -E3/RT) C (3)
D E r4 = Z4exp( -E4/RT) D2 (4)We assume that the Viton A does not decompose until the LX-10 reaches the deflagration state and reacts exothermically. Here i is the mass concentration of a reactant i. The quantities ri, Zj and Ej are the reaction rate, frequency factor and activation energy, respectively, for a reaction j. The components A and B are the solid species - and -HMX, C is a solid intermediate and D and E are intermediate and final gas products. The determination of the chemical kinetic parameters of Table 1 is described below.
2.54 cm
FIGURE 2. 2D cylindrical wedge mesh with the LX-10, gap, and 4130 steel. The temperature of the surface of the steel is increased at the rate 2 o
C per hour.
After the Arrhenius reaction rates have increased to the point where changes are occurring on the time scale of sound propagation, a switch is made to a burn model in which the reactants are converted to products in a single reaction step. This switch in models is made for two reasons. The first is that the computational capabilities and methods are not yet available to resolve reaction zones which can be on the time scale of 1-104 s in the ODTX apparatus may not apply on shorter time scales. It is likely that deflagration rates measured in the strand burner provide a better measure of
reaction behavior on short time scales. We assume that the burn front velocity, V, is a function of the pressure, P, at the front location, and use power-law expressions of the form to describe segments of the burn front curve:
V = Vo(p/po)n
(5)
Here the subscript 0 indicates a reference quantity.Table 1 Chemical kinetic parameters for LX-10
Reactio Ln ZiEi
Qk (J/g)n Step(KJ/g-mole-K)
B C48.45 s(endothermic)
220.39209.38
(endothermic)
C D37.55 s185.26-808.21
(exothermic)
D E27.85 142.60cm3
-6155.75
/s-g(exothermic)The mechanical behavior of the condensed
high-explosive constituents (HMX_A, HMX_B, HMX_C) along with the Viton reactant (Viton_A) are represented by Steinberg-Guinan mechanical models with a 7-term polynomial equation of state. The density and thermal properties of these species are given in Table 2. The constant volume heat capacity does not vary with temperature. Calculated melt and cold curves are used to account for the influence of compression on melting energy. A nonlinear regression procedure was used to determine the coefficients that give an optimal representation of the measurements of the thermal expansion, compressibility, sound speed and the unreacted shock Hugoniot.
The model gas constituents (HMX_D, HMX_E, VITON_B) along with the air in the gap are treated as no-strength materials with gamma-law equations of state. This equation of state provides an approximate representation over much of the pressure range, except at the higher pressures of 10 kbar where the model is less accurate. The -value for the HE gas species is set using a pressure of 1 kbar, a temperature of 2273K and the density and heat capacity from the thermo-chemical equilibrium computer code, CHEETAH for the final product gases.
热门文档