Comparison of TI Voice-Band CODECs for Telephony Applications
SLAA088
TX channel high pass and slope filters (enabled/disabled) RX channel high-pass filter (enabled/disabled)µ-law/linear mode selection PCM loopback DTMF control (TWL1103) Pulse density modulated buzzer control (TWL1103)
3
VBAPs vs AICs VBAPs and AICs are similar in that they are manufactured for voice band applications, are single-chip data conversion systems, and are found in client-side applications. Table 7 compares VBAPs and AICs. Because of their feature-rich nature, the AICs consume more power. The VBAPs are designed for low-power and/or battery-fed applications that need to meet cellular telephone specifications. The AICs are designed for applications which need better resolution and superior signal-to-noise specifications. These applications are typically modem applications. Table 7. Comparison of AICs vs VBAPs CHARACTERISTIC AIC Medium Some No No Yes Some devices Some devices No (linear only) Yes (14 or 16 bits) Some devices No Yes Low Yes Yes Yes Some devices (TWL family) Yes No Yes Yes (13–15 bits in linear mode) No Yes TWL family– yes TCM and TLV families–- limited VBAP
Power consumption? Operate from a single power supply? Operate below 3 V? Designed to meet cellular phone specifications? (CT2, DECT, GSM, etc.) Contain sigma delta converters? Microphone interface? Multi-channel? Pin selectable linear and companding modes? High resolution? Master/slave functionality? Multiple standby power down modes? Programmability?
4
Summary Voice-band codecs can be categorized as audio interface circuits, line card codecs, or voice-band audio processors. Each has been designed with a specific product area in mind. When choosing a voice-band codec, the designer should investigate the feature set and technical specifications to determine the best device for the application.
Comparison of TI Voice-Band CODECs for Telephony Applications

video-on-demand, 3D gaming and video telephony....for developing handset UI and BREW applications ?...Go Online CHIPSET COMPARISON ONLINE TOOL Please ...
Comparison TeakLite-II Architecture Type Traditional,...(audio, voice, telephony) High performance, low ...codecs for full HD applications > SATA/SAS – ...
telephony and high-rate packet data applications. ...For comparison, the fixed rates of the AMR-WB ...narrowband codecs (e.g., EVRC and SMV [3, ...
and/or voice-messaging applications – that are...in-band signaling found in analog telephony to ...Comparison and optimization of packet loss repair ...
support for low bit rate and wideband codecs. ...DSP External Memory Interface Telephony Interface ...Voice Applications Services APIs to access DSP ...
for telephony (ITU) Variations in delay (jitter)...codecs: narrowband / wideband G.711, G.723.1A...applications 基于TI DSP软件应用架构设计的DSP软件,...
telephony equipment and save on consultants’ fees... and integrates with your network/applications ...//www.3cx.com/phone -system/editioncomparison....
voice codecs cannot be guaranteed to reproduce ...Some applications, such as gateways into the PSTN...Tones for telephony events are in the range of ...
comparison of the key issues in sessionbased ...voice, video, data, media applications, using IP... working in real-time, such as IP telephony ...
comparison of the key issues in sessionbased ...voice, video, data, media applications, using IP... working in real-time, such as IP telephony ...
热门文档