文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > IC datasheet pdf-DS1876,pdf (SFP Controller with Dual LDD Interface)
侵权投诉

IC datasheet pdf-DS1876,pdf (SFP Controller with Dual LDD Interface)

IC datasheet pdf-DS1876,pdf (SFP Controller with Dual LDD Interface)

SFP Controller with Dual LDD InterfaceDS1876

Figure 5. Low-Voltage Hysteresis Example

IC datasheet pdf-DS1876,pdf (SFP Controller with Dual LDD Interface)

IC datasheet pdf-DS1876,pdf (SFP Controller with Dual LDD Interface)

A delta-sigma DAC has a digital output using pulse-density modulation. It provides much lower output ripple than a standard digital PWM output given the same clock rate and filter components. Before tINIT, the DAC outputs are high impedance. The external RC filter components are chosen based on ripple requirements, output load, delta-sigma frequency, and desired response time. Figure 6 shows a recommended filter.

For illustrative purposes, a 3-bit example is provided in Figure 7.

In LUT mode the DACs are each controlled by an LUT with high-temperature resolution and an OFFSET LUT with lower temperature resolution. The high-resolution LUTs each have 2NC resolutions. The OFFSET LUTs are located in the upper eight registers (F8h-FFh) of the table containing each high-resolution LUT. The DAC values are determined as follows:

DAC value = LUT + 4 x (OFFSET LUT)

An example calculation for MOD1 DAC is as follows:Assumptions:

1) Temperature is +43NC

2) Table 04h (MOD1 OFFSET LUT), Register FCh = 2Ah3) Table 04h (MOD1 LUT), Register AAh = 7BhBecause the temperature is +43NC, the MOD1 LUT index is AAh and the MOD1 OFFSET LUT index is FCh.

MOD1 DAC = 7Bh + 4 x 2Ah = 123h = 291

Figure 6. Recommended RC Filter for DAC Outputs in Voltage Mode and Current Sink Mode

For all device addresses sourced from EEPROM (Table 02h, Register 8Bh), the default device addresses are A2h and B2h until VCC exceeds POA allowing the device address to be recalled from the EEPROM.

Four delta-sigma outputs are provided: MOD1, MOD2, APC1, and APC2. With the addition of an external RC filter, these outputs provide 10-bit resolution analog outputs with the full-scale range set by the input REFIN. Each output is either manually controlled or controlled using a temperature-indexed LUT.

Delta-Sigma Outputs

16 _____________________________________________________________________________________

上一页第16页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email