J. Cent. South Univ. (2012) 19: 3378–3384 DOI:

10.1007/s11771-012-1417-3
Preparation and properties of composite polymer electrolyte modified with
nano-size rare earth oxide
XIAO Wei(肖 围), LI Xin-hai(李新海), GUO Hua-jun(郭华军), WANG Zhi-xing(王志兴),
YANG Bo(杨波), WU Xian-wen(吴贤文)
School of Metallurgical Science and Engineering, Central South University, Changsha 410083, China
© Central South University Press and Springer-Verlag Berlin Heidelberg 2012
Abstract: Poly(vinylidene uoride-co-hexa uoropropylene) (PVDF-HFP) based composite polymer electrolyte (CPE) modified with CeO2, La2O3 and Y2O3 nano-rare earth oxides was prepared by phase inversion technique. Physical and chemical properties of the modified CPEs were studied by SEM, TG-DSC and electrochemical methods. The results show that the CPE modified with 10% La2O3 (mass fraction) has the best practical applicability, which indicates that the thermal and electrochemical stability can reach over 400 ºC and 4.5 V, respectively, and temperature dependence of ionic conductivity follows Vogel-Tamman-Fulcher (VTF) relationship and ionic conductivity at room temperature is up to 3.3 mS/cm. The interfacial resistance Ri reaches a stable value about 557 after 6 d storage.
Key words: poly(vinylidene uoride-co-hexa uoropropylene); composite polymer electrolyte; nano-rare earth oxide; lithium ion polymer battery
1 Introduction
In order to overcome practical safety of traditional liquid electrolyte in lithium ionic battery, more and more attention has been paid to the novel polymer electrolyte due to its excellent advantages such as no-leakage of electrolyte, high energy density, exible geometry and improved safety hazards [1–2]. Poly(vinylidene fluoride- co-hexafluoropropylene) (PVDF-HFP) is considered to be the most suitable matrix material for fabricating polymer electrolyte because PVDF-HFP has relatively low crystallinity due to the copolymerization effect between VDF and HFP and high ionic conductivity due to more amorphous region compared to other materials such as PVDF [3–5]. However, the mechanical performance of the PVDF-HFP based polymer electrolyte cannot meet the practical requirements. Adding the inorganic llers such as silica (SiO2), copper oxide (CuO), titania (TiO2) and molecule sieve into the polymer matrix can improve the physical strength as well as increase the ionic conductivity due to the improved absorption level of electrolyte solution [6–10]. Except for these effects, they can act as a solid plasticizer hindering the reorganization of polymer chains and interact with polar groups by Lewis acid-base reaction [1, 2, 11]. So, the properties such as ionic conductivity,
lithium ions transference number and activation energy for ions transport can gain much improvement. Although inorganic fillers modified PVDF-HFP based composite polymer electrolyte (CPE) were reported in many literatures, there was less literature to report the CPEs modified by nano-rare earth oxides, which are widely used in the field of functional materials such as catalyst preparation, optical glass and magnetic materials due to their special physical and chemical properties [12–13]. In the present work, the novel PVDF-HFP based CPEs modified with nano-size CeO2, La2O3 and Y2O3 rare earth oxides are prepared by phase inversion technique. Physicochemical and electrochemical properties of nano- rare earth oxides doped PVDF-HFP based CPEs exhibit more distinguishing improvement compared with pure PVDF-HFP electrolyte. In order to investigate the mechanism about the CPEs in more detail, the distinguishing improvement is studied by SEM, TG-DSC, electrochemical impedance spectroscopy (EIS) and linear sweep voltammetry (LSV).
2 Experimental
2.1 Materials and preparation of CPEs
PVDF-HFP (Atofina, Kynar 2801) was used as polymer matrix in this work. Nano-size CeO2 (20–30 nm,
Foundation item: Project(2011FJ1005) supported by the Major Provincial Science and Technology Program of Hunan Province, China; Project
(2010qzzd0101) supported by the Central College on the 2010 Operational Costs of Basic Research Program, China
Received date: 2011 12 28; Accepted date: 2012 06 24
Corresponding author: LI Xin-hai, Professor, PhD; Tel: +86–731–88836633; E-mail: xwylyq2006@126.com
Physicochemical properties of a novel composite polymer electrolyte_教育学/心理...1.2 Preparation of modified nano-La2O3 Appropriate amount of nano-La2O3 ...
Preparation and electroc... 暂无评价 4页 2.00元 Physical Properties and ....properties of composite polymer electrolyte of poly(methyl methacrylate) and ...
Preparation and electrochemical properties of LiNiCoM...And the composite containing 2.0 wt% PPy ...containing liquid electrolyte between the tested ...
polymer matrices widely used in the processes of different GPEs preparation. ...electrolyte are very closely linked with the surface properties of the ...
Keywords: composite polymer electrolyte membrane, polymer gel electrolyte, ...et al., Preparation and properties of the composite microporous PVDF-HFP/...
ber composite gel polymer electrolyte with an ...properties of the as prepared composite electrolytes...Preparation of porous separator A certain amount ...
Morphology and conductivity of in-situ PEO-LiClO4-TiO2 composite polymer electrolyte_专业资料。维普资讯 http://www.cqvip.com JCn.ot nvTcn1r070—380 .et...
composite polymer electrolyte_能源/化工_工程科技_...www.elsevier.com/locate/electacta Preparation of ...The physicochemical properties of the CPE were ...
Preparation_of_monodispe... 5页 2财富值 Synthesis of Poly(methyl... 暂无...electrochemical properties of composite polymer electrolyte based on poly ...
Preparation and biological properties of a novel ...So n-HA/polymer composite scaffolds have been ...Modified Eagle medium (D-MEM) (10% fetal ...
热门文档