J. Cent. South Univ. (2012) 19: 3378 3384 36–38 m2/g), La2O3 (20–30 nm, 25–28 m2/g) and Y2O3 (20–30 nm, 25–28 m2/g) rare earth oxides were purchased from Rare-Chem Hi-Tech Co, Ltd, China. PVDF-HFP and rare earth oxides were dried under vacuum for 12 h at 60 and 120 ºC prior to use, respectively. Both analytical grade solvent N,N-dimethylformamide (DMF) and pore-forming agent polyethylene glycol with low relative molecular mass of 200 g/mol (PEG-200) were directly used without further purification. At first, different contents of nano-size oxide were added to anhydrous ethanol with ultrasonic vibration for 3 4 h and a certain amount of PVDF-HFP was dissolved in DMF with continuous stirring, in which the mass ratios of nano-rare earth oxide to PVDF-HFP were 0.06, 0.08, 0.10, 0.12 and 0.14. Then, two kinds of the aforesaid solution were mixed with continuous vigorous stirring for 3 4 h at 40 °C. After forming homogeneous casting solution, the wet free-standing membrane was fabricated by casting with a doctor blade. And the desirable CPE membranes were obtained by conventional phase inversion technique. To prepare desirable CPEs, the as-prepared PVDF-HFP based CPE membranes must be activated by immersing into the 1.0 mol/L LiPF6-EC/DMC/EMC (1:1:1, volume ratio) liquid electrolyte solution at room temperature for 1 h in an argon-filled glove box to protect from moisture. Meanwhile, as a control sample, the PVDF-HFP based polymer electrolytes without nano-size rare earth oxide were also prepared under the same conditions in this work.
2.2 Properties characterizations
In order to measure the liquid electrolyte uptake ratio (A) of CPEs, the as-prepared electrolyte membranes with 14 mm in diameter were immersed into 1.0 mol/L LiPF6-EC/DMC/EMC (1:1:1, volume ratio) solution at room temperature for 1 h in an argon-filled glove box to activate. The liquid electrolyte uptake ratio (A) is calculated with Eq. (1), in which m1 and m0 are the masses of the wet and dry membranes, respectively:
A m1 m0 100%
m(1)
For morphological features of the CPEs membranes observation, a scanning electron microscope (SEM, JSM6301F) with an accelerating voltage of 20 kV was employed to examine the membrane surface sputter coated with gold under vacuum atmosphere. Thermogravimetry and differential scanning calorimeter (TG-DSC) measurements were carried out on a Perkin-Elmer Pyris-1 analyzer. The measurements were performed at a heating rate of 10 ºC /min from 40 to 400 ºC. A flow of nitrogen gas was maintained over the perforated pan to avoid any contact with atmospheric
3379
moisture. The sample mass was maintained in the range of 12 15 mg and an empty aluminum pan was used as a reference.
The ionic conductivity of the CPEs was determined by EIS according to Eq. (2), where σ is the ionic conductivity; R is the bulk resistance of the symmetrical cell; l and S are the thickness and the area of the specimen, respectively. The as-prepared electrolyte membranes were sandwiched between two stainless (SS) blocking electrodes to fabricate the SS/CPE/SS model cell. The EIS tests were measured over an AC excitation amplitude of 5 mV and frequency range from 1 Hz to 100 kHz at various temperatures (293–363 K, the cells were thermostated during measurements) using a CHI660b frequency response analyzer (Shanghai Chenhua, China).
l
R S (2)
Electrochemical stability window of the CPEs was determined by running LSV in three-electrode cell using stainless steel as the blocking working electrode, lithium as both the counter and the reference electrode and polymer electrolyte as the electrolyte. The LSV tests were carried out using the same system as that in EIS at a scanning rate of 5 mV/s. Additionally, the interfacial stability was studied by investigating the interfacial resistance Ri change versus different storage time of the blocking model cell Li/ CPE/Li.
3 Results and discussion
3.1 Effect of nano-oxide content on electrolyte
uptake ratio
The dependence of electrolyte uptake ratio of CPEs on the different contents of nano-rare earth oxides is shown in Fig. 1. It can be obviously seen from Fig. 1 that the electrolyte uptake ratios are affected by doping different kinds and contents of nano-rare earth oxide. Generally, the three kinds of nano-oxides demonstrate similar dependence on their doped contents. The electrolyte uptake ratio increases with increasing the doping contents of nano-rare earth oxide, which can reach the maximum at 10% (mass fraction) and then decreases with further increasing contents. Similar results are observed in PVDF-HFP based CPEs modified with other nano-inorganic fillers such as nano-Al2O3, and ZSM-5 [14–16]. It is obviously observed that the modified membrane with 10% La2O3 (mass fraction) shows the highest electrolyte uptake ratio up to 262% compared with CeO2 and Y2O3 modified membranes, which may be partly attributed to abundant micro-pores in the surface and inner of the modified membrane and partly to the Lewis acid-base interactions between the
Physicochemical properties of a novel composite polymer electrolyte_教育学/心理...1.2 Preparation of modified nano-La2O3 Appropriate amount of nano-La2O3 ...
Preparation and electroc... 暂无评价 4页 2.00元 Physical Properties and ....properties of composite polymer electrolyte of poly(methyl methacrylate) and ...
Preparation and electrochemical properties of LiNiCoM...And the composite containing 2.0 wt% PPy ...containing liquid electrolyte between the tested ...
polymer matrices widely used in the processes of different GPEs preparation. ...electrolyte are very closely linked with the surface properties of the ...
Keywords: composite polymer electrolyte membrane, polymer gel electrolyte, ...et al., Preparation and properties of the composite microporous PVDF-HFP/...
ber composite gel polymer electrolyte with an ...properties of the as prepared composite electrolytes...Preparation of porous separator A certain amount ...
Morphology and conductivity of in-situ PEO-LiClO4-TiO2 composite polymer electrolyte_专业资料。维普资讯 http://www.cqvip.com JCn.ot nvTcn1r070—380 .et...
composite polymer electrolyte_能源/化工_工程科技_...www.elsevier.com/locate/electacta Preparation of ...The physicochemical properties of the CPE were ...
Preparation_of_monodispe... 5页 2财富值 Synthesis of Poly(methyl... 暂无...electrochemical properties of composite polymer electrolyte based on poly ...
Preparation and biological properties of a novel ...So n-HA/polymer composite scaffolds have been ...Modified Eagle medium (D-MEM) (10% fetal ...
热门文档