航路间隔标准
As illustrated in Figure 1, the width of the Given the baseline spacing and the widths of the straight departure path is characterized by VSTO,C. departure paths, the equivalent divergence angle can The subscript STO,C is subsequently used to denote be written as Straight Conventional departure operations.
Similarly, VDIV,C characterizes the width of the DWDQ^ G V G G WDQ STO,R(d)) + d departure path whose center line is angled relative to WDQ DIV,R G FRV `. (3) the straight departure path and the subscript DIV,C is used to denote Diverging Conventional departure At distances shorter than d, the spacing of the operations. The only functional dependence of the diverging departure paths exceeds the baseline widths of the departure paths and associated standard spacing (see Figure 2). Should 3-NM lateral deviations considered in this study is the distance d separation of the nominal departure tracks not already from the divergence point. This functional be established at a given distance d, application of the dependence is indicated by the variable argument (d) ELSO standard assumes that conventional 15-degree in VSTO,C(d) and VDIV,C(d). divergence is established up to the point where the
required lateral spacing (e.g., 3 NM) of the nominal
Given the minimum divergence angle Dmin and
departure tracks exists and that courses do not
the widths of the departure paths, the spacing of the
converge thereafter.
diverging departure paths can be defined as
s(d) = n(d) – G WDQ STO,C(d)) – d (taQ DIV,C(d)) / cos(Dmin)). (2)

At distance d, Equation 2 states that the departure paths are spaced s(d) apart (see Figure 1). This spacing can be viewed to represent the
minimum spacing of the dispersions that define the departure paths of diverging operations authorized by the currently applicable standard. It serves as spacing baseline for all ELSO standard application Figure 2. RNAV Departure Path Spacing requirements reported here. Thus, all ELSO standard application requirements are defined to provide a
departure path spacing that is equivalent to the ATL Operational Considerations
ATL is one of the numerous airports in the NAS baseline spacing given by Equation 2 and illustrated
which employs RNAV SID procedures. This section in Figure 1.
discusses key conventional and RNAV departure
RNAV Operations
operational considerations at the airport.
RNAV departure operations do not typically
ATL has five parallel east-west runways, with involve ATC issuance of initial radar vectors.
two runways (8L/26R and 9R/27L) designated as Instead, RNAV departure procedures provide defined
primary arrival runways, two designated as primary course guidance from the runway end to the planned
departure runways (8R/26L and 9L/27R), and the route of flight. In this case, the current divergence
standard requires that the courses of the RNAV fifth runway (10/28) typically used as either a
departure or arrival runway depending on demand. routes differ by 15 degrees (Dmin) or more.
Figure 2 illustrates the spacing baseline and
application of the ELSO standard to RNAV departure operations. As shown in the figure, its application enables a reduced divergence angle E. It is defined to provide, at distance d, spacing of the departure paths in a manner equivalent to the baseline spacing s(d).
The airport typically operates in either a dual departure runway or a triple departure runway configuration. Aircraft will all arrive and depart to the east, which is referred to as an East Operation, or all arrive and depart to the west, which is known as a West Operation. Figure 3 depicts a West Operation dual departure runway configuration.
{STARS) RWAV Standard lnstrument Departures (SI ...Terminal busy en route and 2erminal airs paw E ...Reduced Separation between Aircraft b Capacity 5. ...
where appropriate separation between successive ...Standard Terminal Arrival Routes (STARS) from the...If the departures have been waiting in a long ...
热门文档