Fig. 3. Offset parabola efficiency with 3D corner reflector antenna of 1.7
wavelength feed at 5.8 GHz frequency.
图3: 1.7波长的3D角反射器天线做馈源时,5.8GHz频段偏馈抛物面天线的效率
Truncated 3D corner reflector feed for 5.8 GHz
用于5.8GHz的削顶3D角反射器馈源
As shown in the picture above, 3D corner reflector antenna has relatively good
efficiency when it is illuminating dishes whose F/D is 0.9 and higher. The reason for this is its very narrow vertical radiation angle. That is, the vertical radiation angle is too narrow for the illumination of SAT TV offset parabolas, and horizontal is too wide, as shown in the figures. It is obvious that 3D corner reflector antenna could be also adjusted for offset parabolas with a lower F/D if the diagram could be widen in vertical plane and narrowed in horizontal plane so that they are approximately equal to each other and at the same time retain all other good characteristics of this antenna. Since widening and narrowing of the diagram is possible only by modifying of the geometry of reflector, the change of dimensions and shape of the reflector was the course I took. However, the change of geometry on this geometrically symmetrical reflector carried the danger of loosing some of the basic characteristics of geometric optics, by whose principles this antenna functions. That would immediately mean the complete change of the most of the essential and valuable characteristics of the

本文介绍用改进型3D角反射天线, 为6厘米业余无线电通信频段STA卫星电视 或WLAN频段5.8GHz频道的偏馈抛物面天线作馈源。 Introduction 引言 The problems that occur...
本文介绍用改进型3D角反射天线, 为6厘米业余无线电通信频段STA卫星电视 或WLAN频段5.8GHz频道的偏馈抛物面天线作馈源。 Introduction 引言 The problems that occur...
热门文档