文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 机械/仪表 > How to Measure Flatness with Optical Flats
侵权投诉

How to Measure Flatness with Optical Flats

平面平晶检测平面度

no attempt should be made to maintain a wedge. A band pattern such as shown in figure 3 will appear.

How to Measure Flatness with Optical Flats

The bands are to be interpreted as contour lines on a map, the interval being 11.57 millionths of an inch (293.8 nm). Thus the total flatness error is equal to half the band count between points of contact. In the figure shown the 12 bands between high spots indicate a valley 6 bands or 69.42 millionths deep.

Additional Suggestions Regarding Flatness Tests

1. The bands should be viewed as nearly perpendicularly as possible. If viewed from an

increasingly oblique angle the value of 11.57 millionths per dark band can increase

significantly; there will be fewer bands and they tend to straighten.

2. Where an observation from a distance of 10 times the diameter is impractical, a

monochromatic light employing the bent beam principal such as the Van Keuren type L light is recommended.

3. Van Keuren quartz flats distort very little with temperature changes. However, a warm

flat may distort a cold surface. Therefore, all work should be allowed to come to a

common temperature before being tested.

4. The number of bands which appear is not an indication of the flatness of the surface but

relates only to the steepness of the wedge. The bands may be made fewer and father apart by pressing on the optical flat until they are most conveniently spaced for evaluation.

5. A perfectly flat surface will show straight and evenly spaced bands. In this case, a test

with the bands running at right angles to their original position will show curved bands and make it possible to evaluate the curvature.

Effective Band Values

Viewing Band

Angle Value

(micro (degrees) inches)

10 68.6

20 33.8

30 23.1

40 18.00

50 15.1

60 13.4

70 12.3

80 11.8

90 11.6

- 3 -

上一页第3页

你可能喜欢

热门文档

相关文档

  • 光学平板

    The determination of the flatness of any ...in the fringes to measure the surface accurately....with repeated use, optical flats can lose their ...

  • 南开大学光学工程内部课件Oct 28th

    l, the optical path length is change by l and...Typical Measurement Results – Flatness/Shape – ...To measure the temporal coherence, we need detect...

  • 近代光学 12-Oct 22nd

    Interferometer is the optical setup which split ...Typical Measurement Results – Flatness/Shape – ...To measure the temporal coherence, we need detect...

  • Bowl Feed Technique

    amounts, the figure, i.e., flatness of the surface, may be well ...In order to measure surface roughness on polished optical flats, multiple ...

  • Bowl Feed Technique

    amounts, the figure, i.e., flatness of the surface, may be well ...In order to measure surface roughness on polished optical flats, multiple ...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email