VVα1=as andα2=as.
Vb1Vb22.5.6 Order Band Pass
th
(24)
In the 6ª order band pass enclosureboth chambers are
tunedand the acoustical equivalent circuitis depicted inFigure 8,and the same considerations to the4ª

order band pass enclosure will also apply here.
Figure 9. High Pass section, 1st order.
ZH1=

ZHIGH+
1s C1
(26)
Figure 10. Low Pass section, 1st order.
Figure 8. Acoustical equivalent circuit of a 4ª order band pass enclosure.
ZL1=

ZLOW+s L1(27)
The acoustical impedance will be given by (20),where
Zb1=Map1
s
s2
ωb1
+
s
+1
b1QL1
(25)
Figure 11. Band Pass section, 1 order.
st
andZb2is obtained from (22).
The electrical impedance at the voice coil terminalswill be given by (23), andZeb1 andZeb2arecalculated from (10)taking (20), (24)and (25) intoaccount.
3.CROSSOVERS
The passive crossover networksused in this work can be seen inFigures 9 to14,with the high pass,lowpassand band pass sections,from orders1stto 2nd,respectively.
To build a two way or three way crossover network,1st or 2nd order, just pick up the appropriate sectionsconnecting them in parallel. For instance, a three way2nd order crossover can be built paralleling thecircuits from Figures 12, 13and14; in the case of atwo way 1ª order crossover do the same with circuitsfrom Figures 9and10.
TheimpedancesZHIGH,ZLOWandZMID arerepresenting the loads of each one of the highpass,

low pass and band pass sections.
s2+
ZM1=

L2
1s ZMID+L2C2 L2
s
(28)
Figure 12. High Pass section, 2nd order.
s2+
ZH2=

ZHIGH
s1
+
C3 ZHIGHC3 L3
HIGHs2+
L3
(29)
Figure 13. Low Pass section, 2nd order.
AES 115TH CONVENTION, NEW YORK, NEW YORK, 2003 OCTOBER 10-13
热门文档