Red=Kr ωXr;Le=Kl ω(Xl 1)
(2)
Zms=Rms+s Mms+
1s Cms
(3)
1
,Zvc=Ze+
+ZesZea
(7)
WhereKr,Xr,Kl,Xlcorrespond to the non-linearparameters derived after Wright from the driverimpedance curve [6].
Moving the acoustical impedance (Za)to themechanical side,we get the circuit depicted inFigure

3.
Zvcis the electrical equivalent impedance at themoving coil terminals, valid to any driver andallarbitrary acoustical loads (cabinets).
2.1.Infinity Baffle
To the infinitybafflethe acoustical load is theairimpedance radiation,small enough if compared to the other impedances, to be neglected.In this case, theresulting electrical impedance at voice coil terminalswill be given by equation (8).
1.Zvc=Ze+Zes
2.2.Closed Box
Figure 3. Electro mechanical circuit equivalent to the one inFigure 2.
(8)
2
Zma=Za Sd,
(4)
Sdis the loudspeaker effective diaphragm area.Now
moving the mechanical impedances ZmaandZmstothe electrical side, leads to the circuit inFigure 4 [7-

11].
In the case of a closed box, the acoustical load to the driver may be represented by a resistanceRab (dueto internal absorption losses),in series with acomplianceCab (representing the air trapped insidethe box), according to

Figure 5.
Figure 5. Closed box equivalent circuit.
Then the acoustical impedance will be given by (9)
Figure 4. Electrical equivalent circuit of Figure 3.
Zea=
and
B2
Zma
=
Za Sd
B2
s+
(5)
Za=Zb=Rab
1CabRab
,
s
(9)
Zes
B2
.=
Zms
(6)
while the reflected acoustical impedance to the
electrical sidewill correspond to (10).
Blis the force factor,representing the magneticdensity flux (B)trough the gaptimes the effectivewire length (l)inside the gap. Then, the load presentto amplifier output will correspond to Equation (7).
Zea=Zeb=
Zb Sd
(B)2
.(10)
Taking (9) and (10) into (7), we get (11)
AES 115TH CONVENTION, NEW YORK, NEW YORK, 2003 OCTOBER 10-13
热门文档