ANALYSIS OF SIZE EFFECT,SHEAR DEFORMATION AND DILATION IN DIRECT SHEAR TEST BASED ON GRADIENT- DEPENDENT PLASTICITY
第23卷 第7期
岩石力学与工程学报 23(7):1095~1099
2004年4月 Chinese Journal of Rock Mechanics and Engineering April,2004
ANALYSIS OF SIZE EFFECT,SHEAR DEFORMATION AND DILATION IN DIRECT
SHEAR TEST BASED ON GRADIENT-
DEPENDENT PLASTICITY
Wang Xuebin,Tang Jupeng,Zhang Zhihui,Pan Yishan
(Department of Mechanics and Engineering Sciences,Liaoning Technical University, Fuxin 123000 China)
Abstract The paper concerns the issue of size law,localized deformation and dilation or compaction due to shear localization. It is assumed that the shear localization initiates at the peak shear stress in the form of single shear band,and based on gradient-dependent plasticity,an analytical solution on size effect or snap-back is obtained. The results show that the post peak response becomes steeper and even exhibits snap-back with increasing of length. For small specimen,the relative shear displacement when specimen failure occurs is lower than that of larger specimen and the shear stress-relative displacement curve becomes steeper. The theoretical solution on non-uniformity of strains in shear band is obtained and evolution of the relative shear displacement is represented. By resorting to the linear relation between local plastic shear strain and local plastic volumetric strain,the dilation and compaction within shear band are analyzed. Relation between apparent shear strain and apparent normal strain and relation between shear displacement and vertical displacement are established.
Key words gradient-dependent plasticity,direct shear test,shear localization,size effect,dilation,compaction,shear band
CLC number TU 452 Document code A A article ID 1000-6915(2004)07-1095-05
the test,some experimental observations[1method[4
The direct shear test is a widely used soil or rock
~5]
~3]
and
1 INTRODUCTION
test that provides essential design data in stability analysis of slope,foundation and rockburst and so on. The test is inevitably subject to criticisms because of the non-uniformity of stress and strains,which may facilitate the occurrence of progressive failure along the potential shear plane[1]. However,the test is the standard method for the measurement of plane strain strength parameters. To obtain a full understanding of
Received 10 April 2002,Revised 1 June 2002.
* Supported by the National Natural Science Foundation of China(50309004)。
numerical experimental using the finite element
or distinct element method[6
~7]
have been
adopted.
However,it should be pointed out that little effort has been made in the past to study the test through analytical solution,owing to that the analytical solution can not deal with non-uniform plastic shear strain in shear band based on classical plastic theory in which stress only depends on strain.
One of the most promising approaches proposed to model localization relies on the incorporation of
Wang Xuebin:Male,Born in 1975,PhD Candidate at the Liaoning Technical University,Interested in theoretical study and numerical simulation in rock mechanics. E-mail:wxbbb@263.net。
OF THE DIRECT SHEAR TEST Ling Zhang1 and Colin...m to 90 ?m with an average size of 60 ?m....It has also been shown that the dilation in ...
Effect of plastic deformation on the formation of...Test material The alloy composition used in the ...radial dilation as measured using a laser ...
The analysis results can give some guidance for ...dilation, asperity failure and contact area [4,5...direct shear test of joint in rock mass ...
in geomechanics analysis of wellbore stability and ...dilation, and downhole pressure during drilling (Zemanek...we take into account the effect of mud infilt...
grain-size analysis, granularmetric analysis, granulometric...dilation dilatancy dilative soil pore pressure parameters...test direct shear test unconfined compression...
Dilation 膨胀 Disintegration 瓦解 Splitting test 劈...Effect 效应 Direct action 直接作用 Load effect ...analysis 分析 shear 剪切,剪力 flexure 弯曲 bending...
? Effect of intersection in stress-strain matrix ...? direct shear test peak strength residual ...1 ?? 3 —— shear dilation In high confining ...
Effect of intersection in stress-strain matrix ? ...direct shear test ? ? peak strength residual ...1 ??3 —— shear dilation In high confining ...
? ? Effect of intersection in stress-strain ...? direct shear test residue strength ? ? ...Shear dilation In low confining pressure, ?1 ? ...
in the insitu residual shear strengths and the ...but the ability of such analysis methods to con...volumetric strains through the sand’s dilation ...
热门文档