SC70, Single/Dual Low-Voltage, Low-Power µP Reset Circuits
MAX6381–MAX6390


not work with the open-drain outputs of theMAX6383/MAX6386/MAX6389/MAX6390. The resistorvalue used is not critical, but it must be small enoughnot to load the reset output when VCCis above the resetthreshold. For most applications, 100k is adequate.

a negative-going pulse applied to VCC, starting above theactual reset threshold and ending below it by the magni-tude indicated (reset comparator overdrive). The graphindicates the typical maximum pulse width a negative-going VCCtransient may have without causing a resetpulse to be issued. As the magnitude of the transientincreases (goes farther below the reset threshold), themaximum allowable pulse width decreases. A 0.1µFcapacitor mounted as close as possible to VCCprovidesadditional transient immunity.
The MAX6381–MAX6390 are guaranteed to operateproperly down to VCC= 1V. In applications that requirevalid reset levels down to VCC= 0, a pulldown resistor toactive-low outputs (push/pull only, Figure 2) and apullup resistor to active-high outputs (push/pull only) willensure that the reset line is valid while the reset outputcan no longer sink or source current. This scheme does
Ensuring a Valid RESETOutput Down to VCC= 0
_______________________________________________________________________________________7

MAX6387XS16D5-T中文资料 隐藏>> 元器件交易网www.cecb2b.com 19-1839; Rev...(MAX6384/MAX6385/MAX6386) o Auxiliary RESET IN (MAX6387/MAX6388/MAX6389...
MAX6387XS16D5-T中文资料 隐藏>> 元器件交易网www.cecb2b.com 19-1839; Rev...MAX6385 MAX6388 MAX689 MAX6383 MAX6390 MAX6381–MAX6390 1 (MAX6382/ MAX...
VTH/°C VCC falling at 10mV/?s from VTH + 100mV to VTH - 100mV D1 D2 Reset Timeout Period MAX6381–MAX6389 (See Reset Timeout table) D3 ...
MAX6389XS16D5-T中文资料 隐藏>> 元器件交易网www.cecb2b.com 19-1839; Rev...MAX6385 MAX6388 MAX689 MAX6383 MAX6390 MAX6381–MAX6390 1 (MAX6382/ MAX...
MAX6389XS16D5-T中文资料 隐藏>> 元器件交易网www.cecb2b.com 19-1839; Rev...(MAX6384/MAX6385/MAX6386) o Auxiliary RESET IN (MAX6387/MAX6388/MAX6389...
MAX6386XS16D5中文资料 暂无评价 13页 免费 TBA820M-D08-T中文资料 5页 ...Auxiliary RESET IN (MAX6387/MAX6388/MAX6389) ? VCC Reset Timeout (1120ms...
MAX6388XS16D1中文资料 暂无评价 13页 免费 TBA820M-D08-T中文资料 5页 ... MAX6388XS16D1-T中文资料 隐藏>> 元器件交易网www.cecb2b.com 19-1839; Rev...
MAX6388XS16D3中文资料 暂无评价 13页 免费 MAX6388XS16D3+中文资料 暂无评价 ...VCC V ms ms TYP MAX 5.5 13 11 7 6 VTH + 1.5% V VTH + 2.5%...
VTH/°C VCC falling at 10mV/?s from VTH + 100mV to VTH - 100mV D1 D2 Reset Timeout Period MAX6381–MAX6389 (See Reset Timeout table) D3 ...
热门文档