所包括吃饭八角枫
h K=[14.4-Vo-(p o -p~)l/[p~Tr(d23+ d 2+ d'd23)]
(19)
and the diameter d of the smaller conical segment of the cone is the same as the diameter of the intake pipe. Thus, mounting a compensator in the intake line of a piston pump decreases inertial pressure oscillations in the intake pipe in section 1-2 by increasing the coefficient k23, which is inversely proportional to the fluid inertia in the compensator. At the same time, installing a compensator causes additional pressure oscillations, which can be decreased by choice of the proper compensator charge. If the fluid inertia in section 1-2 of the pipe is two or more orders of magnitude larger than the fluid inertia in the compensator - as occurs in the delivery line of a mud pump - the problem of choosing compensator parameters reduces to determining its charge VoPo to provide the specified pressure nonuniformity in the compensator. For the intake line of a mud pump in which the fluid inertia is roughly the same as the fluid inertia in the compensator, the cross sectional area of the fluid column must be chosen as well as the charge in the compensator. The area must be chosen to provide the specified decrease z5 of the inertial component of the pressure at point 2. For a cylindrical compensator, the diameter d23 can be determined from Eq. (18).
REFERENCES . T. M. Bashta, S. S. Rudnev, and B. B. Nekrasov, Hydraulics, Hydraulic Machines, and Hydraulic Tools[in Russian], Mashinostroenie, Moscow (1982). O. I. Verzilin, Modern Mud Pumps[in Russian], Mashinostroenie, Moscow (1971). M. A. Karaev, Hydraulics of a Mud Pump[in Russian], Nedra, Moscow (1975). Problem Book of Hydraulics, Hydraulic Mach
ines, and Hydraulic Tools[in Russian], Vysshaya Shkola, Moscow (1989).
,
3. 4.
247

Analyzing the effectiveness of an intake compensator for a piston mud pump (J).Chemical and Petroleum (3):243-247. Engineering,1995,31 (M [2] 许...
热门文档