method for power control is proposed for broadband, packet-switched TDMA wireless networks. By observing the temporal correlation of cochannel interference when transmitters can send data contiguously, a Kalman filter is used to predict interfence power in
A Kalman-Filter Method for Power Control in Broadband Wireless Networks
Kin K. Leung
AT&T Labs, Room 4-120
100 Schulz DriveRed Bank, NJ 07701
Email: kkleung@research.att.com
Abstract:A Kalman- lter method for power control isproposed for broadband, packet-switched TDMA wirelessnetworks. By observing the temporal correlation of co-channel interference when transmitters can send datacontiguously, a Kalman lter is used to predict interfencepower in the future. Based on the predicted interferenceand estimated path gain between the transmitter andreceiver, transmission power is determined to achieve adesired signal-to-interference-plus-noise ratio (SINR).Performance results reveal that the Kalman- ltermethod for power control provides a signi cantperformance improvement. Speci cally, when a messageconsists of 10 packets on average, the 90 and 95 percentileof the SINR by the new method are 3.94 and 5.53 dBabove those when no power control is in use, and lie just0.73 and 1.04dB below the upper-bound performance ofthe optimal power control, respectively, in a system with4-sector cells and an interleaved frequency assignment of areuse factor of 2/8 [WL98]. As a by-product, these resultsshow that the cell layout and assignment scheme combinedwith the new method for power control can be used tosupport high-speed data services.1. INTRODUCTION
There is a growing demand for broadband wirelessnetworks as work-at-home, telecommuting and Internetaccess have become very popular. High-speed packetservices are needed to provide: a) ef cient access to WorldWide Web for information and entertainment on theInternet, b) remote access for telecommuters to theircomputer and data at the of ce, and c) multimedia servicessuch as voice, image and video. Given the proliferation ofInternet Protocol (IP) networks, it is important to considerand design broadband wireless networks that support IP.Towards this goal, it is natural to allow terminals and basestations to send data in multiple packets contiguously on a"connectionless" basis.
Dynamic transmission power control has been widelystudied and practiced to combat and manage interferencein cellular radio networks; see e.g., [Z92a], [FM93],[EKBNS96] and [RZ98]. Speci cally, power control hasbeen shown to be a useful technique to improveperformance and capacity of time-division-multiple-access(TDMA) wireless networks. In addition to performanceimprovement, power control is actually essential in solvingthe near-far problem so that the base station can receive the
same power level from various transmitting terminals incode-division-multiple-access (CDMA) networks [AC93],[AC94], [EKBNS96]. In this paper, we focus onbroadband, packet-switched TDMA networks with userdata rates up to several megabits per second, link lengths(or cell size) typically less than 10 kilometers andoperating frequency in the range of 1 to 5 GHz.
Existing power control algorithms for wirelessnetworks can be categorized into two classes:signal-basedandsignal-to-interference-ratio (SIR) basedpower control.Signal-based power control [W93] [HWJ97] adjusts thetransmission power based on the received signal strength,which in turn depends on path loss, shadowing and fadingof the radio link between the transmitter and receiver. Incontrast, SIR-based control [Z92a], [Z92b], [FM93],[GVG94] changes the power according to the ratio ofsignal and co-channel interference (possibly plus noise)power levels. (Since only co-channel interference isconsidered here, it is simply referred to asinterferenceinthe following.) It has been shown that SIR-based powercontrol outperforms signal-based control, although theformer is more complicated in implementation.
To the best of our knowledge, power controlalgorithms in the literature are proposed explicitly orimplicitly for circuit-switched networks. Many of themsuch as [Z92b], [FM93], [GVGZ93], [GVG94] and[UY98] are iterative algorithms that require re-adjustmentsof transmission power over the entire call duration. As aresult, such algorithms are applicable mainly to calls withrelatively long holding time. For the same reason, theycannot be applied directly to packet-switching networksdue to the burstiness of data packets, coupled withirregular transmission schedule in these networks.Therefore, there is a need to devise an appropriate powercontrol algorithm for broadband, packet-switched TDMAnetworks, and this is the topic of this paper.
2. MOTIVATION FOR NEW POWER CONTROLTo help illustrate our ideas for wireless IP networks, letus assume that time is divided intoslots,and the slot sizeis appropriately chosen to support the applications, whilecontrolling the protocol overhead to achieve ef cient radiobandwidth usage. Let each data message be divided into anumber of packets, each of which can be transmitted inone time slot. As in typical IP networks, the messagelength (in terms of the number of packets or equivalently
(0); //initialize with a measurement x_est_last = z_real + frand()*0.09; float sum_error_kalman = 0; float sum_error_measure = 0; for (...
% [x, V, VV, loglik] = kalman_filter(y, A, C, Q, R, init_x, init_V, ...) % % INPUTS: % y(:,t) - the observation at time t % ...
源于1957年他在哥伦比亚大学的一篇博士 论文和1960年发表的论文《A New Approach to Linear Filtering and Prediction Problems》,60年代Kalman 把状态空间模型引入滤波...
y〔n〕=Cx〔n〕 为 A = 〔1.1269-0.49400.1129 1.0000 0 B = 〔-0.3832 0.5919 0.5191〕; C = 〔1 0 0〕; 我们的目标是设计 Kalman 滤波...
卡尔曼全名 Rudolf Emil Kalman,匈牙利数学家,1930 年出生于匈牙利首都布达佩斯。...4. 简单例子 (A Simple Example) 这里我们结合第二第三节, 举一个非常简单...
(cm == 'A') mtype = 2; else error('Unkown measurement model.'); ...(sd,T.nmeas); % Kalman gain % Initialize filter L_init = L_max/2.0...
Kalman Filter介绍_数学_自然科学_专业资料。卡尔曼滤波(kalman filter)最简单...4 简单例子(A Simple Example) 这里我们结合第二第三节,举一个非常简单的例子...
(A,[B B],C,0,-1,'inputname',{'u' 'w'},'outputname','y'); Q = 1; R = 1; [kalmf,L,P,M] = kalman(Plant,Q,R); kalmf = kalmf(...
Kalman 滤波 在学习卡尔曼滤波器之前,首先看看为什么叫“卡尔曼”。跟其他著名...(k-1k-1)对应的 covariance,A’表示 A 的转置矩阵,Q 是系统过程的 ...
Kalman滤波中文版 17页 1下载券 kalman滤波的C与C++实现 10页 1下载券 ... Kalman滤波的公式推导...
热门文档