(4)
(5)
2.3. Stroke of punches
The ICP algorithm and localization algorithm are used for geometric alignment and registration of three-dimensional surface models, as described in the previous section. The algorithm starts with two surfaces, the design surface and the unfolded surface, and iteratively determines the transformation by considering pairs of corresponding points on the surfaces and minimizing the distance between the design surface and the unfolded surface. According to the displacement distance, points on the flat unfolded surface adjust the strokes of the pressing punches. The punches are arranged between the unfolded surface and the design surface. The point of the curved piece is projected onto the point on the flat piece, and the correspondence stroke is assumed based on a point-to-point distance. As stated earlier in Fig. 1, the pressing machine has nine pressing rods in the inner region of the workpiece and sixteen pressing rods along the constraint edges. Hydraulic pressures are used for all rods so that the inner rods push the plate and the edge rods pull the plate.
Therefore, the initial stroke
can be easily assumed by:
(6)
Where ri and ui denote the vertical offset of points on the desired shape and the location of the pressing punch, respectively. The points of the workpiece are projected onto the desired surface and the corresponding points can be easily obtained.However, the head of the rod makes contact with the workpiece as the punch is pressed with the above initial stroke. To that will be imposed on the ith point of the unfolded flat surface
Process design for multi... 暂无评价 6页 2.00元 Method of closed loop... Springback adjustment fo... 暂无评价 13页 免费 Enhancement of Increment.....
Multicore Bundle Adjustment-Manual_计算机软件及应用_IT/计算机_专业资料。三维计算机视觉匹配相关资料Multicore Bundle Adjustment Manual Changchang Wu University of...
Multi--scale Approach for CFRP Composite Simulation by JSTAMP-NV and DIGIMAT_材料科学_工程科技_专业资料。Multi-scale Approach for CFRP Composite Simulation...
for sheet metal part, multi-point forming (MPF) technology is discussed in...3.1 Element group design and shape adjusting mode Height adjustment for ...
216-219. ON MULTI-IMAGE RECONSTRUCTION FROM HISTORIC PHOTOGRAPHS I. ...Multi-image Adjustment of Historic Images of Unknown Orientation with the ...
However, there are no analytical models for variation analysis in multi-station compliant assembly systems. It is critical to develop realistic models for ...
Similar to freeways except inclusion of a few different adjustment factors to determine FFS ? Base conditions for multi-lane highways: – 12’ lanes – ...
Site design plane adjustment work is heavy, if modify the design elevation,...In modern construction engineering, general multi-storey buildings when the ...
热门文档