comparing_white_leds
Comparing White Light LEDs to Conventional Light Sources
Luminaire Efficacy
A more accurate way to compare LED performance with traditional sources is to measure the performance of luminaires designed for and lamped with each type of source. The metric used for comparison is called luminaire efficacy, expressed in lumens per watt (lm/W). Figure 1 presents a sampling of luminaire efficacy data for recessed downlights, based on DOE CALiPER product testing.
Luminaire efficacy is typically lower than source efficacy due to optical losses and, in some cases, thermal factors affecting source performance (e.g., for LEDs and fluorescent lamps). As illustrated in Figure 1, luminaire efficacy can vary between products—even when using the same type of light source—due to variations in optical components, ballast or driver efficiency, and thermal management.The photometric test procedure developed for LED luminaires (IESNA LM-79-08) can also be used to test LED replacement lamps, which have integrated drivers and thermal management. Remember, however, that the performance of LED replacement lamps (like other temperature-sensitive sources, e.g., CFLs) will be affected by thermal conditions in the luminaire in which they are installed.
1200
Luminaire Output (lumens)

1000
800
600
400
200
00
10
20
30
40
50
60
70
Luminaire Efficacy (lm/W)
Lumen Depreciation
All light sources diminish in output
over their operating life. Consequently, most lighting installations are designed around the average (i.e., mean or design mean) lumen output of the lamp or, in critical applications, on output at the end of life. By extension, when comparing the energy efficiency of different types of light sources and luminaires, it is important to consider mean or end-of-life efficacy, and not initial efficacy.
Figure 1. Comparison of Luminaire Efficacies for Recessed Downlights with LED, Compact Fluorescent (CFL), Cold-Cathode Fluorescent (CCFL), Halogen-IR and Incandescent Sources (includes ballast, driver and thermal losses, where applicable). Lamps and retrofit products were tested in the same downlight fixture housing. Source: CALiPER
Lifetime for traditional light sources is based on lamp failure, with mean lumen output measured at a percentage of rated lamp life, typically 40% for fluorescent and metal halide lamps. LEDs can continue to operate long after their light output has dropped below useful levels, so their design life is instead based on a percentage of initial lumens. In the LED industry, these lifetime specifications are known as L50 and L70, which represent estimated operating hours to 50% and 70% of initial light output, respectively.
Currently, high-performance linear fluorescent lamps offer mean lumen outputs that are as high as 95% to 97% of their initial values. Lumen depreciation for LEDs is not as well understood. Lumen depreciation for LEDs is not yet as well understood; with useful life defined as L70, a linear depreciation curve would imply mean lumen values of about 85% of initial output. To achieve comparable mean luminaire efficacy in this case, LED luminaires must have a higher initial efficacy than their fluorescent or other counterparts. Table 1 illustrates how a hypothetical LED luminaire with initial luminaire efficacy equal to a high-performance T8 fluorescent luminaire will yield a lower mean efficacy, decreasing net
comparing_white_leds 4页 免费 thermal_mgt_white_leds 2页 免费 color_quality_of_white_l... 2页 20财富值 energy_efficiency_white_... 暂无评价 2页...
Color Quality of White LEDs Building Technologies Program Correlated Color Temperature (CCT) CCT describes the relative color appearance of a white light ...
29页 免费 Comparing community stru... 10页 1财富值 comparing_white_leds 4页 免费 COMPARING GENOMES 暂无评价 8页 免费喜欢此文档的还喜欢 K神贴 34页 ...
29页 免费 Comparing community stru... 10页 1财富值 comparing_white_leds 4页 免费 COMPARING GENOMES 暂无评价 8页 免费喜欢此文档的还喜欢...
Energy-Efficient Lighting Lifecycle – White Paper LED Lighting: More energy-...Figure 2: When comparing LEDs to other types of lighting systems, it is ...
11页 1财富值 comparing_white_leds 4页 免费 Normal shift shuttle bus... 4页 5财富值喜欢此文档的还喜欢 PhilipsLumileds LED 37页 免费 电能质量国际标准...
white/color LED driver from the mAhXLifeTM family...Comparing all cathodes and regulating VOUT for the...to use LEDs with consistantly lower VF voltage. ...
white/color LED driver from the mAhXLifeTM family...Comparing all cathodes and regulating VOUT for the...to use LEDs with consistantly lower VF voltage. ...
Characterizing LEDs For General Illumination Applications: Mixed-color and phosphor-based white sourcesNadarajah Narendran ,NishanthaMaliyagoda, Lei Deng, and ...
Huawei_NE5000E_White_Paper 隐藏>> Huawei NE5000E Huawei’s Multi-Chassis ...19 Comparing the CRS-1 to the NE5000E ......
热门文档