文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 电子/电路 > Low-cost antenna-in-package solutions for 60-GHz phased-array systems
侵权投诉

Low-cost antenna-in-package solutions for 60-GHz phased-array systems

Low-Cost Antenna-in-Package Solutions for 60-GHz Phased-Array Systems

Dong Gun Kam, Duixian Liu, Arun Natarajan,

Scott Reynolds

IBM T. J. Watson Research Center

Yorktown Heights, NY dgkam@us.ibm.com

Abstract—A low-cost, fully-integrated antenna-in-package solution for 60-GHz phased-array system is demonstrated. Sixteen patch antennas are integrated into a 28 mm x 28 mm ball grid array together with a flip-chip attached phased-array transmitter or receiver chip. The packages have first been fabricated using low temperature co-fired ceramic technology, and then built using conventional printed circuit board processes for lower manufacturing cost. Antenna chamber measurement has shown ~5 dBi unit antenna gain across the 60-GHz frequency band covering all four IEEE 802.15.3c channels. The packaged transmitter and receiver chipsets, each mounted on an evaluation board, have demonstrated beam-steered, non-line-of-sight links with data rates up to 5.3 Gb/s.

Brian A. Floyd

Dept. Electrical and Computer Engineering

North Carolina State University

Raleigh, NC

wirebonds were used elsewhere [4]. The fused-silica antenna was suspended above an air cavity atop a Kovar metal frame whose height matched the thickness of the silicon chip. This technique was used for either chip-on-board mounting or land grid array packages. Although these prototype packages allowed for early demonstrations of the line-of-sight (LOS) 60-GHz link [5], their assembly was complicated and expensive, and the overall approach was not easily scalable to larger arrays.

Since LOS cannot be guaranteed in many applications, phased arrays have received increasing attention recently. Although numerous phased-array ICs have been implemented at various millimeter-wave (mmWave) frequencies including 60 GHz [6]–[8], many of the challenges that remain are in the

Keywords—Antenna-in-package; millimeter-wave package; realm of package design. Multiple fixed-beam packaging phased-array antennas; 60 GHz

solutions have been demonstrated at 60 GHz [9]–[11]; however, little work has been published on cost-effective 60-GHz

I. INTRODUCTION phased-array antennas and packages. Incorporating phased-The 60-GHz band is extremely attractive for multi-Gb/s array antennas into a package is difficult for several reasons: 1)

wireless communication, because of the large unlicensed the influence of package-level coupling and mismatches often bandwidth available (~7 GHz worldwide) and the high leads to the detuning of the antennas or reduced performance in allowable transmit power (40 dBm of equivalent isotropic bandwidth and efficiency; 2) layer stack-up should be carefully radiated power in the USA). Among the many potential large determined so that both electrical performance and mechanical

reliability requirements are met; 3) heat sinks or cooling volume applications of 60-GHz technology are wireless peer-to-peer file transfer, uncompressed high-definition video devices should not interfere with the antennas; and finally, 4)

streaming, and wireless docking. The recent advances in the packaging solution should be compatible with mainstream CMOS and SiGe technologies have enabled single chip manufacturing and assembly processes to capture high volume solutions in silicon, making 60-GHz technology more markets. In this paper, we present a low-cost 60-GHz AiP

solution. commercially attractive [1]. For the 60-GHz market to flourish,

however, low-cost antenna and packaging solutions are required, not only low-cost ICs. II. LTCC PACKAGES The short wavelength at 60 GHz (5 mm in free space) allows antennas to be embedded within a package or integrated on a chip. Antenna-in-package (AiP) solutions have been recognized to have advantages over antenna-on-chip solutions in gain and radiation efficiency [2]. For several years, we have been working toward low-cost 60-GHz AiP solutions that are suitable for mass production. Our initial approach to this goal was to develop proof-of-concept antennas in fused silica [3], and then to develop prototype packaging [4]. In [3], cavity-backed folded-dipoles were realized with 7 dBi gain, >90% efficiency, and >20 GHz bandwidth (return loss > 10 dB). To attach these antennas to the silicon chips, a simple flip-chip interconnect was used for the 60-GHz connection, while

Low temperature co-fired ceramic (LTCC) has been popular in the RF packaging industry because it offers low-loss dielectrics, good thermal conductivity, and a high degree of integration due to cavities and embedded passives. In this work, LTCC’s excellent electrical properties at mmWave frequencies are key to meeting our antenna gain specifications. The loss tangent of the ceramic material used here was measured as ~0.006 at 60 GHz, which is an order of magnitude smaller than that of conventional printed circuit board (PCB) materials. Fig. 1 shows the package stack-up with the integrated superstrate aperture-coupled patch antenna. The air cavity between the antenna and the ground plane improves bandwidth and radiation efficiency while suppressing surface wave [3]. The

第1页

TOP相关主题

你可能喜欢

热门文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email