文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 电子/电路 > Low-cost antenna-in-package solutions for 60-GHz phased-array systems
侵权投诉

Low-cost antenna-in-package solutions for 60-GHz phased-array systems

Low-cost antenna-in-package solutions for 60-GHz phased-array systems

improving the bandwidth. The power plane beneath the aperture reflects backside radiation. Because the 60-GHz transmitter (Tx) [12] or receiver (Rx) [13] IC is flip-chip attached to the bottom of the package, a quasi-coaxial structure is implemented by adding four ground vias around each signal via [14]. Since the coaxial structure has high impedance due to minimum via separation requirement, the antenna feed is designed to be 50 and a quarter-wavelength transformer is used for impedance matching. More discussion on the antenna design can be found in [15].

Once layout was completed, full-wave simulation was

conducted as final verification. Fig. 2 shows the simulated

antenna element gain for one particular direction

(perpendicular to the package), with different curves showing the responses at the four different IEEE 802.15.3c channels.

The gain of each antenna is computed with all other ports terminated with matched loads, and mutual coupling among the

antennas is also included. Antenna gain is dependent upon its location, showing 3–6 dBi gain across frequency. The average gain of the Tx is about 1 dB lower than that of the Rx because

the same single-ended antenna was used in both designs and a socket, and then soldered down to an evaluation board and balun with 1 dB loss was added to the Tx.

measured in an anechoic chamber using an automated testbed

Fig. 3 shows the fabricated LTCC package. Sixteen fixture, as shown in Fig. 4. Fig. 5 compares the simulated gain antennas and either the 60-GHz phased-array Tx or Rx IC have and measured power of the Rx antennas at one of the IEEE been fully integrated in a 288-pin (28 mm x 28 mm) ball grid

Low-cost antenna-in-package solutions for 60-GHz phased-array systems

channels. For comparison purposes, both quantities have been

上一页第2页

TOP相关主题

你可能喜欢

热门文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email