太阳能电池板安装手册

INSTALLATION MANUAL FOR CRYSTALLINE SOLAR PHOTOVOLTAIC MODULES Rev.G
Artificially concentrated sunlight should not be shown on the SPV module. The electrical characteristics are indicated value of Pmax under standard test conditions (Irradiance of 1000W/m2, AM 1.5 spectrum, and cell temperature of 25°C).
Under normal conditions, a solar photovoltaic module is likely to produce more current and/or voltage than reported under standard test conditions. Accordingly, the value of Isc and Voc marked on this module should be multiplied by a factor of 1.25 when determining component voltage ratings, conductor current ratings, fuse sizes, and sizes of controls connected to the SPV output.
15. MODULE WIRING
Each module has two 4mm2 diameter type standard 90°C sunlight resistant output cables each terminated with plug & play connectors. This cable is suitable for applications where wiring is exposed to the direct rays of the Sun. We recommend that all wiring and electrical connections comply with the appropriate national electrical code.
For field connections, use the minimumφ4mm2 diameter copper wires insulated for a minimum of 90°C and Sunlight resistant as well.
The minimum and maximum outer cable diameters of the cable are 5 to 7mm. Refer to table 5 for the maximum electrical rating of series fuse.
16. MAINTENANCE
Under most weather conditions, normal rainfall is sufficient to keep the SPV module glass surface clean. If dust or dirt
build-up becomes excessive, clean the glass only with a soft cloth using mild detergent and water. Do not clean the modules with cold water during the warmer hours of the day in order to avoid creating any thermal shock that maybe damage the module.
Use caution when cleaning the back surface of the module to avoid penetrating the substrate material. SPV Modules that are mounted flat (0° tilt angle) should be cleaned more often, as they will not ''self clean'' as effectively as modules mounted at a 15° tilt or greater. At least once a year it is recommended the checking the tightness of terminal screws and the general condition of the wiring. Also, check to be sure that mounting hardware is tight. Loose connections will result in damage for array.
Changed SPV modules must be the same type. Do not touch the live parts of cables and connectors. Use appropriate safety equipment (insulated tools, insulating gloves, etc.) when handling modules.
Cover the front surface of SPV modules by an opaque or other material when repairing. The SPV modules when exposed to sunlight generate high voltage and are dangerous.
WARNING: For any electrical maintenance, the PV system must first be shut down. Improper maintenance can cause lethal electric shock and/or burns.
Address: No.2 Trina Road, Trina PV Park, New District, Changzhou, Jiangsu, P.R. China
KX-TDA安装手册_manual_信息与通信_工程科技_专业资料。KX-TDA30/KX-TDA100...章节 6 安装 (Installation)— KX-TDA30 介绍安装 KX-TDA30 的工序。提供...
图 10 Main Rack 11 图 11 选择 IC200UDR040/140/440 图 12 Module Catalog...追日程序流程 15 表1 名称 E_Stop start Manual_Auto MorningSun_Contr ...
TM---Manual--TMG安装与配置手册_IT/计算机_专业资料。MS TMG安装与配置手册ForeFront TMG Manual Book Shanghai Redmaple ForeFront TMG Manual Book 1 前期准备...
atv61安装手册s_installation_manual_cn_v2_信息与通信_工程科技_专业资料。Altivar 61 异步电机变频器 0.37 (0.5 HP) ... 45 kW (60 HP)/200 - 240...
RVT Manual CN---中文版rvt新型安装手册_电子/电路_工程科技_专业资料。ABB 新版彩屏RVT样本RVT 功率因数控制器 RVT 安装和操作说明 目录前言 ......
10G OEO 使用手册manual-1_信息与通信_工程科技_专业资料。10G OEO 传输子...4 2. INSTALLATION AND CONNECTION 安装与连接 ... 4 ...
FSP180-60SPV中文资料_电子/电路_工程科技_专业资料。元器件交易网www.cecb2b... Manual selection Frequency: 47~63Hz Input Current: 7A (RMS) @115V AC,...
MTA-ADW-1 开关量控制使用手册Manual_V2.0_2010.10_电子/电路_工程科技_...安装尺寸图 6.MTA-ADW-1油门执行器 开关量控制使用手册 www.hesmor.de 目录...
Installation/SystemRequirements --- 3 怎样获得 怎样获得Ubuntu安装光盘 安装光盘...module=via_rhine multicast=yes port=MII speed=10MB/s *-network DISABLED ...
KNT-SPV01 光伏发电实训系统 使用说明书(2011 年...Module Catalog 对话框 (5)在如图 13 所示的 ...追日程序流程 15 表1 名称 E_Stop start Manual_...
热门文档