Yttria doped nanocrystalline zirconia powder was prepared by spray-pyrolysis technique. Powder crystallized into tetragonal form, as dense and compositionally homogeneous polycrystalline spheres. X-Ray diffraction (XRD) and high resolution transmission ele
BOULC’H F ET AL: Domain size distribution of Y-TZP nano-particles using XRD and HRTEM
heated length) heated at 600°C. One advantage of thisone-step synthesis is to obtain nanocrystalline powderof zirconia at low temperature in which no amorphousphase was detected with either XRD or with Ramanspectrometry. Microscopic scanning observationsshow smooth submicronic spherical particles more orless agglomerated, dense and homogeneous inchemical composition (Boulc’h et al., 2001). Particlessize distribution was studied by laser granulometry.The profile shows a narrow distribution of sizes withmean value of around 800 nm. Stoichiometry ofpowder was found to be similar to the precursorsolution as measured by chemical analyses. Materialswere characterized by a high purity with a quantity ofsilicium less than 0.1 wt% and only traces of hafnium.Raman spectrometry reveals tetragonal zirconia.In the diffraction pattern, the peak broadening isdue to three factors: strains, faulting and crystallinedomain size. If we assume that the 2.5Y2O3-ZrO2crystals are free of strains and faulting, peak broadeningis only due to crystalline domain size. The domainsize is calculated by the Scherrer formula (Warren,1969):
L = (0.9 λ) / (θ * cosθ0),
(1)
where L is the crystalline domain size (in nm), λ thewavelength (in nm), θ the full width at half maximum(FWHM - in radian) and θ0 the diffraction angle (°).L is considered as an average crystal dimensionperpendicular to the reflecting planes.
Yet, an additional instrumental broadening, arisingfrom slit width, penetration in sample and imperfectfocusing, is generally observed. Therefore, a standardsample, in which the particle size is large enough toeliminate all particle–size broadening, is used in order tocorrect the instrumental broadening. The standard peakis recorded under the analyzed sample conditions.Thus, the Scherrer formula is considered as:
L = (0.9 λ) / ( θ * cosθ0) with θ = (FWHM2sample - FWHM2standard )1/2.
(2)
Under HRTEM conditions, depending on thecrystallographic orientation with respect to the electronbeam, crystalline domains may be imaged as a dotslattice or more frequently as a fringe domain. Suchfringe domains are sufficient to reveal the existenceof crystalline domains and to measure their sizes.However, on the 2.5Y2O3-ZrO2 particles, thicknessvariation and domain overlapping lead to quite noisyimages making difficult the measurements of fringedomains size on the HRTEM images. In such case,the geometrical phase analysis method, developed byHytch, provides a method of interest to measure thecrystalline domain size (see for instance Hytch andGandais, 1995). The method can be summarized asfollows. Basically, a fringe domain corresponds to aspatial frequency (g) and a constant phase. Therefore,if a Fourier filtering followed by phase extraction isapplied to a HRTEM image, a crystalline domain isidentified by a constant phase area for a selected gvector.
The main advantage of the phase image method isthat the crystalline domain appears as an homogeneousarea characterized by an almost constant gray level.The rest of the particle which does not correspond to theselected g vector is defined by a very rapidly oscillatingcontrast on the map phase. Such both differentbehaviors simplify the image analysis processingfurther carried out to determine the size distribution.Transmission electron microscopy observationswere carried out on a Jeol 3010 microscope operatingat 300 kV (point resolution r = 0.25 nm). Powder wasdeposited on carbonated copper grid.
RESULTS
XRD
XRD pattern was characterized by broad peaks:indeed, 200, 202, 113 and 004 are not well resolved,as shown in Fig. 1. The absence of splitting in twodiffraction lines, characteristic of tetragonal structure,may be attributed to small crystalline domain size.Such XRD pattern is consistent with both tetragonaland cubic zirconia. Therefore, Raman spectrometrywas a necessary preliminary step in order to concludethat 2.5Y2O3-ZrO2 powder, prepared by spray-pyrolysis, crystallized into the tetragonal phase.The Scherrer formula was applied to 111 peak.Indeed, this latter presents the maximum of intensityand is well-resolved in contrast to the broad200,202,113 and 004 peaks. As detailed in Fig. 1, an
This simple approximation is valid as long as thecrystalline domain size is smaller than 100 nm.Powder X-Ray diffraction was carried out using aSiemens D500 θ/2θ diffractometer with the Bragg-Brentano geometry from 20 to 80° (0.04° in 20 step,10s counting time) equipped with a rear monochromator(CuKα radiation, λ = 1.5406 ). FWHM wasdetermined by deconvolution of pseudo-Voigt shapedpeaks with Profile Fitting software (Diffract-AT,Socabim, Paris).
particles was calculated to be around 21 nm ...(BJH) pore size distribution plot (inset) of ...Using the BJH method and the desorption branch ...
by XRD, UV-vis, IR, DLS, TEM, and HRTEM. ...improve the homogeneity of the copper particles. ...size distribution may be further improved by ...
investigated by XRD, SEM, TEM, HRTEM, and EDS...size and improved the distribution of sintering ...nanostructured silica particles using high-energy ...
domain, such materials have been shown to ...of nano-sized Nd hydride, ferro-boron, and ...size distribution, with most particles being about...
prepared from TiO2 particles treated with KOH ...of tubular materials with narrow size distribution....XRD and HRTEM results suggest that nano?bers ...
of Mesoporous CeO2 Nano- and Microstructures ...size distribution and another broad peak in the ...and spindle-like particles using a onestep procedure...
Soil Using Zero Valent Iron Nano-Particles ...Its degradation in soil is well known and ...Hydrodynamic particle size distribution of iron ...
Toxicity of nano- and micro-sized ZnO particles in human (1)_生物学_自然...and XRD, respectively ZnO (nm) Size and distribution nm (mean ± SD) 70...
various dendritic metal and alloys nano/microstructures...particles with a desired morphology, size, phase,...size distribution of the dendrites (Figure 1g). ...
c) SEM and d) HRTEM images of TiO2–SnO2 ...peak of SnO2, nano-SnO2 particles and the nanocrystallites...we determined the pore-size distribution and...
热门文档