文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 建筑/土木 > WI-8710-8100-0099 Rev.B 汽机油系统设备及管道安装作业指导书
侵权投诉

WI-8710-8100-0099 Rev.B 汽机油系统设备及管道安装作业指导书

13. 有关成品保护措施related product protection

13.1管道运至现场后保护好两端封头,防止杂物进入内部而破坏内部清洁度。 Two ends shall be covered properly to prevent from any sundries.

13.2油管在施工完毕,严禁在管道上用火焊开孔,破坏内部清洁度。

After installation, flame welding is not allowed to open holes in the piping to prevent from spoiling inner cleanliness.

13.3管道安装过程中不得碰坏润滑油站设备上的部件。

Components on LO station shall not be damaged during installation.

13.4设备周围搭设隔离带,上面铺设开箱板,防止高空落物损坏设备。

Barrier shall be set up around equipment, and package board shall be placed on top to prevent from damage by fallen object.

14. 相关计算书 calculation

14.1 润滑油站吊装钢丝绳的选用selection of slings for LO station

润滑油站重量为23吨,拟采用6×37+1、φ32.5mm、22m长的钢丝绳一对。润滑油站受力分析见附图A。

Its weight: 23t. one pair of 6×37+1 φ32.5mm wire rope 22m long. Refers to the attached LO station lifting stress diagram.

α=30º

由受力分析图可知

Finding from stress diagram:

4Tcosα=G

4Tcos30º=23 可得so: T=6.6t=66KN

经查6×37、φ32.5mm 、 1670MPa钢丝绳的破断拉力总和为:546KN

the total fracture force of 6×37,φ32.5mm, 1670Mpa wire rope: 546KN 安全系数K为: K=546/66=8

safety factor: K=546/66=8

所以选用φ32.5mm的钢丝绳安全。

WI-8710-8100-0099, Rev.B page 18 of 19

上一页第18页

你可能喜欢

  • 汽轮机检修
  • 背压式汽轮机
  • 汽轮机轴承
  • 汽轮机发电
  • 施工现场安全管理制度
  • 汽轮机安装
  • 管道安装施工方案

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email