MAX3420 -usb资料
USB Peripheral Controllerwith SPI InterfaceMAX3420E


The MAX3420E connects to any microprocessor using3 or 4 interface pins (Figure 1). On a simple micro-processor without SPI hardware, these can be bit-banged general-purpose I/O pins. Four GPIN and fourGPOUT pins on the MAX3420E more than replace theµP pins necessary to implement the interface. Althoughthe MAX3420E SPI hardware includes separate data-in(MOSI, (master-out, slave-in)) and data-out (MISO,(master-in, slave-out)) pins, the SPI interface can alsobe configured for the MOSI pin to carry bidirectionaldata, saving an interface pin. This is referred to as half-duplex mode.
Figure 1. The MAX3420E Connects to Any MicroprocessorUsing 3 or 4 Interface Pins
Two MAX3420E features make it easy to connect tolarge, fast chips such as ASICs and DSPs (see Figure2). First, the SPI interface can be clocked up to 26MHz.Second, a VLpin and internal level translators allowrunning the system interface at a lower voltage than the3.3V required for VCC.
Figure 2. The MAX3420E Connected to a Large Chip

The MAX3420E provides an ideal method for electricallyisolating a USB interface (Figure 3). USB employs flowcontrol in which the MAX3420E automatically answershost requests with a NAK handshake, until the micro-processor completes its data-transfer operations overthe SPI port. This means that the SPI interface can runat any frequency up to 26MHz. Therefore, the designeris free to choose the interface operating frequency andto make opto-isolator choices optimized for cost or per-formance.
Figure 3. Optical Isolation of USB Using the MAX3420E
2_______________________________________________________________________________________
Connect load capacitors (20pF max) to ground on both XI and XO. XI can also be driven with an external 12MHz ±0.25% clock. If driving XI with...
Connect load capacitors (20pF max) to ground on both XI and XO. XI can also be driven with an external 12MHz ±0.25% clock. If driving XI with...
热门文档