工程塑料成型10大问题
ENGINEERING POLYMERS:
THE ‘TOP TEN’ MOULDING PROBLEMS
By R. Wilkinson, E. A. Poppe, Karl Leidig, Karl Schirmer
The ten problems listed below occur often when moulding semi-crystalline engineering polymers such as
POM, PA, PBTand PET. In this series of articles the authors describe simple ways to identify and avoid them.
Chapter 1. Moisture in the granules
1. Moisture in the granules2. Feed system too small3. Wrong gate position4. Hold time too short5. Wrong melt temperature6. Wrong tool temperature7. Poor surface finish
8. Problems with hot runners9. Warpage
10. Mould deposit
Many plastics absorb moisture from the atmosphere; how much they absorb depends on the type of resin.Moisture in the granules, even if it is only surface condensation, can cause problems in parts moulded withengineering polymers. Many kinds of undesirable effects can occur, including processing problems, poorsurface on moulded parts, or loss of mechanical properties. It is seldom possible to establish whether there ismoisture present by means of visual examination alone. The authors prepared this article to give moulders whoprocess a broad range of plastics some useful guidance on how to handle those polymers that are sensitive to moisture.

1

topten02-The DuPont Plastic Design Guide-10 Top Tips_能源/化工_工程科技_专业资料。ENGINEERING POLYMERS: THE ‘TOP TEN’ MOULDING PROBLEMS By R. Wilk...
topten02-The DuPont Plastic Design Guide-10 Top Tips_能源/化工_工程科技_专业资料。ENGINEERING POLYMERS: THE ‘TOP TEN’ MOULDING PROBLEMS By R. Wilk...
热门文档