文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 能源/化工 > topten01-The DuPont Plastic Design Guide-10 Top Tips
侵权投诉

topten01-The DuPont Plastic Design Guide-10 Top Tips

工程塑料成型10大问题

topten01-The DuPont Plastic Design Guide-10 Top Tips

Drying Plastic Materials

Most engineering polymers require the moisture in the granules to be below a certain maximum level for

processing. The need for drying depends mainly on how sensitive the raw material is to water. Naturally, themoisture content of the material as delivered, the type of packaging and the period of storage are also

important criteria. For example, polyamide is generally packed in bags with a barrier layer of aluminium, sothat it can be used straight out of the bag. However, most processors of PAprefer to dry the resin in any case,even though drying is not necessary if the material is used within one hour.

PETand PBT, on the other hand, are far more critical where moisture is concerned and must always be driedto ensure that impact strength of the moulded parts is not affected. Another factor is that these resins pick upmoisture very rapidly after drying, so that moulders should exercise special care when handling open

containers of PETand PBT, when they are in transport or conveyor systems, as well as regarding their dwelltime in the hopper. Thus, in unfavourable climatic circumstances PETcan absorb enough moisture in 10

minutes to exceed the maximum permitted moisture content for moulding of 0,02 per cent. Drying regrind andfully saturated granules (e.g. in the case of containers which were left standing around open) requires specialcare. In these cases the recommended drying times are usually not enough. Fully saturated polyamide mayneed more than 12 hours to dry. The yellowing associated with such treatment is practically unavoidable. Thefollowing guidelines should therefore be followed: Always store sprues and regrind in closed containers. Close containers or bags that have been partially used. Keep a lid on the hopper.

How to Dry

It is important to follow correct drying procedures if you want good quality mouldings. Simple hot air driers ofvarious types are not adequate for drying polyesters, for example, but dehumidified-air drier systems are

acceptable. Only these can provide the necessary constant and adequate drying, whatever the ambient climaticconditions may be. Apart from keeping the correct drying temperature, it is important to ensure that the dewpoint of the drying air remains lower than ≤–20°C. When operating multiple-container installations with

different filling heights and bulk density, it is also important to ensure that the air throughput in each containeris sufficient.

Measuring Moisture Content

Moisture in the granules can be measured with commercially available measuring instruments, e.g. with themanometric or the Karl-Fischer method. To eliminate sources of error, the sample should be taken from welldown in the hopper, and should be sealed in an appropriate container. Special heat-sealable sachets coated withPE and aluminium are suitable, as well as laboratory-type glass containers that can be hermetically sealed.

2

topten01-The DuPont Plastic Design Guide-10 Top Tips

上一页第2页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email