min to completely remove the dissolved oxygen and to assure anaerobic conditions. A continuous magnetic stirrer was applied at the bottom of the reactor in order to keep the photocatalyst particles in suspension status during the whole experiment. A 0.4 mL of gas was sampled intermittently through the septum, and hydrogen was analyzed by gas chromatograph (GC-14C, Shimadzu, Japan, TCD, nitrogen as a carrier gas and 5Å molecular sieve column). All glassware was carefully rinsed with deionized water prior to use. The conditions. Four low power UV-LEDs (3 W, 365 nm) (Shenzhen LAMPLIC Science Co. Ltd. China), which were positioned 1 cm away from the reactor in four different directions, were used as light sources to trigger the photocatalytic reaction. The focused intensity and areas on

the flask for each UV-LED was ca. 80.0 mW/cm2 and 1 cm2, respectively. The QE was calculated according to the following equation:
QE[%]
number of reacted electrons
100
number of incident photons
number of evolved H2 molecules 2
100
number of incident photons (1)
Photoelectrochemical Measurements. Photocurrent was measured on an electrochemical analyzer (CHI660C Instruments) in a standard three-electrode system using the prepared samples as the working electrodes with an active area of ca. 1.0 cm2, a Pt wire as the counter electrode, and Ag/AgCl (saturated KCl) as a reference electrode. A molecular weight: 20000) and 0.5 ml ethanol to make a slurry. Then, the slurry was coated onto a 2 cm×1.2 cm F-doped SnO2-coated glass (FTO glass) electrode by the o
C for 30 min. All investigated electrodes have a similar film thickness (15 m).
The significantly enhanced electrochemical performance compared with pure graphene and Fe2O3 nanoparticles may be attributed to the positive synergetic effect ...
Enhanced dispersion of carbon nanotube in silicone rubber assisted by graphene...Many reports investigated the synergetic effect of different ?llers to make ...
热门文档