(100-x)MxG or graphene as co-catalyst under the same conditions but replacing 95M5.0G with (100-x)MxG or GO. Blank TiO2 was also prepared following the same procedure as above except that the first addition of MoS2/graphene hybrid co-catalyst was eliminated. The detailed data are listed in Table S1. Moreover, in order to further investigate the effect of the content of the MoS2/graphene (95M5.0G) co-catalyst on the photocatalytic hydrogen activity of TiO2, the mass ratio of 95M5.0G/TiO2 was changed from 0.2% to 3.0% (0.2, 0.5, 1.0, and 3.0 wt %) by varying the amount of 95M5.0G (see Table S2). For the purpose of comparison, 0.5%-95M5.0G-TiO2 mixture was prepared by simple mechanical mixing of the pristine TiO2 and 0.5 wt % of 95M5.0G without the hydrothermal process.
Characterization. JEM-2100F electron microscope (JEOL, Japan), using a 200 kV accelerating voltage. X-ray diffractometer (Rigaku, Japan) with Cu K radiation ( = 0.15418 nm) at a scan rate (2 ) of 0.05os-1. The accelerating voltage and the applied current were 40 kV and 80 mA, respectively. The Brunauer-Emmett-Teller specific surface areas (SBETsamples were evaluated on the basis of nitrogen adsorption isotherms measured at -196oC using a Micromeritics ASAP 2020 gas adsorption apparatus (USA). All the samples were degassed at 180 oC before nitrogen adsorption measurements. The BET surface area was determined using adsorption data in the relative pressure (P/P0) range of 0.05-0.3. The via the Barret-Joyner-Halender (BJH) method.1 The nitrogen adsorption volume at the relative pressure (P/P0) of 0.99 was used to determine the single-point pore volume and the average ultrahigh vacuum VG ESCALAB 210 electron spectrometer equipped with a multichannel detector. The spectra were excited using Mg K (1253.6 eV) radiation (operated at 200 W) of a twin anode in the constant analyzer energy mode with a pass energy of 30 eV. Raman spectra were recorded at room temperature using a micro-Raman spectrometer (Renishaw InVia) in the backscattering geometry with a 514.5 nm Ar+ laser as an excitation source. UV-visible absorbance spectra were obtained for the dry-pressed disk samples by a UV-visible spectrophotometer (UV-2550, Shimadzu, Japan). BaSO4 was used as a reflectance standard in a UV-visible diffuse reflectance experiments.
Photocatalytic testing. The photocatalytic H2-production experiments were performed in a 100 mL Pyrex flask at ambient temperature and atmospheric pressure, and three openings of source (20 cm far away from the photocatalytic reactor). The focused intensity on the flask was ca. 20 mW/cm-2. In a typical photocatalytic experiment, 80 mg of TiO2/MoS2/graphene composite photocatalyst was suspended in 80 mL of aqueous solution containing 25% of ethanol scavenger in volume. Prior to irradiation, the suspension of the catalyst was dispersed in an ultrasonic bath for 10 min, and then bubbled with nitrogen through the reactor for 40
The significantly enhanced electrochemical performance compared with pure graphene and Fe2O3 nanoparticles may be attributed to the positive synergetic effect ...
Enhanced dispersion of carbon nanotube in silicone rubber assisted by graphene...Many reports investigated the synergetic effect of different ?llers to make ...
热门文档