拨动开关规格书

拨动开关规格书

1.ELECTRICAL CHARACTERISTICS 电气性能规格:

ITEM项目

文件编号版本版次页码页数生效日期

TEST CONDITIONS 测试条件

1/0

第 页,共 页

PERFORMANCE 表现

80mΩMax80毫欧以下

1.1

CONTACTRESISTANCE接触电阻INSULATIONRESISTANCE绝缘电阻

MEASURED AT SMALL CURRENT(100mA OR LESS)1000Hz

在微小电流(100mA)以下测试.

APPLY A VOLTAGE OF 500V DC FOR 1MIN.TO FOLLOWINGPORTIONS AFTER WHICH MEASUREMENT SHALL BE MADE:(1)BETWEEN BODY AND CONDUCTOR.

(2)BETWEEN CONDUCTOR NOT TO BE CONTACT.输入500V DC电压1分钟,按以下接触方法测试:(1)塑胶体与针脚之间(2)不接触的针脚之间

1.2

100mΩMIN100兆欧以上

1.3

DIELECTRICSTRENGTH耐电压

AC 500V ims(50-60Hz)FOR 1 MIN TRIP CURRENT:0.5mA(1)BETWEEN BODY AND CONDUCTOR.

NO DAMAGE TO PARTS

(2)BETWEEN CONDUCTOR NOT.TO BE CONTACT.

ARCING,OR BREAKDOWN ETC.

输入AC500V(50-60Hz)电压,1分钟感应电流为0.5mA,按以下

没有绝缘破坏等异常.

接触方法测试. (1)塑胶体与排脚之间.(2)不接触的排脚之间

PRACTICALTEMPERATURE

1.4

RANGE 使

用温度范围

AT-16℃～+60℃在16℃～+60℃温度内使用

UNLESS OTHER WISE SPECIFIED.THE STANDARD RANGE OF

STANDARDATMOSPHERIC CONDITIONS FOR MAKING MEASUREMENTS ANDATMOSPHEICTESTS ARE AS FOLLOWS:(1)AMBIENT TEMPERA TURE:5℃

1.5

CONDITIONS 测TO35℃.(2)RELATRVE HUMIDITY:45%TO85%.试标准状态在没有指定的情况测试温度,湿渡:

(1)温度为5℃～35℃.(2)湿度为45%～85%2.MECHANICAL CHARACTERISTICS 机械性能规格:

ITEM项目

TEST CONDITIONS 测试条件

PERFORMANCE 表现

300gf±100gf

ELECTRICAL

CHARACTERISTICS SHALL BE

A STATICLOAD OF 300gf SHALL BE APPLIED TO THESATISFIED WITHOUT DAMAGETERMINAL OFR 15 SEC. IN ANY DIRECTION. 在排OR EXCESS 1 VE LOOSENESS脚前端任意一个方向的先端加上300gf力度测试,OF TERMINALS.时间为15秒在排脚中没有裂开,松动等

异常,满足于机械,电器性

能.

2.1

CONNECTIONFORCE动作力

2.2

TERMINALSTRENGTH端子强度