Comparison Of Failure Criteria For Jointed Rock Masses 节理岩体破坏准则比较
Table 3 Hoek and Brown paramters for different
rocks
Hoek andRock TypeRMR
Brown
parametersii
Intact Kota
sandstone89151
Sandstone57151
Gypsum
Plaster2071
Numerical analysis of a powerhouse cavern inthe state of Himachal Pradesh India, namelyNathpa Jhakri Cavern is then taken up. Thepowerhouse cavern has dimensions 216 m × 20 m× 49 m (length × width × height) at a depth of262.5 m below the ground level. The rock massaround the cavern is mainly quartz mica schistwith joints and discontinuities [Bhasin, (1996) andSitharam & MadhaviLatha (2002)]. The measuredin-situ stresses are 4.73 and 6.34 MPa in E-W andN-S and directions respectively and 5.89 MPa invertical direction. The geometry of the cavernalong with the excavation sequence and locationof extensometers is shown in Figure 2.


EL 1022 m
EL 996 m EL 975 m

Figure 2. The rock mass at the site has one set of jointsinclined at 55° with joint frequency of 5 per meterdepth. The joint factor for the rock masscalculated using equation 9 is 22. The RMR value
for the rock mass estimated as per Bieniawski(1973) is 52.
In this paper, numerical analysis of the cavernis carried out using both the failure criteriaexplained. Properties of intact rock at Nathpa-Jhakri cavern are given in Table 4.
Table 4 Properties of intact rock for Nathpa-Jhakri powerhouse cavern
Uniaxial compressive strength (MPa)16Young's modulus (MPa)8591Angle of internal friction (degrees)22
i
Ramamurthy’s Bi2.5Hoek and Brown parameter mi2.03i3.The comparisons between the numericallyRESULTS AND DISCUSSION
predicted and the experimental stress-strainbehaviour of three rocks at different confiningpressures using different failure criteria are shownin Figures 3-5.
100
80
)
aMP60
s (estr soratvi40
De20
0.0
0.2
0.4
0.6
0.81.0
1.2
1.4
1.6
Axial strain (%)
Figure 3. Comparison of stress-strain curves
for intact Kota sandstoneIt can be observed that the predicted stress-strain curves closely follow the experimental dataat all lower and higher confining pressures for thecase of intact Kota sandstone.
International Journal of Rock Mechanics & Mining Sciences 38 (2001) 591–598 Technical Note A stress–strain relation for jointed rock masses Fa-quan Wu...
model for hydraulic fracturing of jointed rock masses during HDR stimulation ...Comparison of the analysis results with the data recorded during the ...
for slope stability analysis in situations where the failure mechanism is not...of the strength and deformation characteristics of rock masses are required ...
Deformability characteristics of jointed rock masses under uniaxial compression_专业资料。Itrainlorao nn cec n ehooy221)1-21nenta ulfoJn MiigSineadTcnlg2(...
the joints and rock material respective criteria. ...comparison with a characteristic length of the ...Macroscopic Failure Condition for Jointed Rock Mass...
Macro-mechanical properties of columnar jointed basaltic rock masses 隐藏>> JCn.ot nvTcn1(011:1324 .etSuhUi.eho.21)824—19DoI010/l710105:4:1.07s17...
Failure Properties of Fractured Rock Masses as ...for the failure criterion of a jointed rock mass...the joints and rock material respective criteria. ...
for the failure criterion of a jointed rock mass...the joints and rock material respective criteria. ...A comparison is performed on an illustrative ...
(2005)08–1275–08 ANISOTROPIC YIELD CRITERION FOR JOINTED ROCK MASSES BASED...Formulation of anisotropic failure criteria incorporating a microstructure tensor[...
3 MECHANICAL MODELS AND FAILURE CRITERIA Much effort has been put into ...An anisotropic strength criterion for jointed rock masses (Chen et al., ...
热门文档