BNS,空间光调制器,文献
where I0 is the maximal intensity at the zero order when the phase profile of the grating becomes a plane wave φBG(x) = 0 with an efficiency of 100% at the zero order.
The power of diffractive order is proportional to its intensity [17]. So, the power of the zero order follows the same cosine function, and it can therefore be continuously adjusted in a range from 0 to maximal power without an extra power loss by just modulating phase depth φ.

3. Controlling the total power of 3D multiple spots
Fig. 3. Schematic diagram of Fourier optics propagation from SLM plane (back focal plane) to
imaging plane.
In a holographic laser system [2,18], generated by a SLM placed in a plane conjugate to the input pupil of a lens such as a microscope, phase-only hologram inducing a phase modulation of φ(x,y) can be used to transform an incident collimated laser beam with wavelength λ into multiple 3D spots. These 3D spots are generated by the beams with an individual quadratic phase factor, i.e. they act as point sources of converging/diverging spherical waves. For example, as shown in Fig. 3 above, when a converging beam with quadratic phase factor x2 y2 λf is just away from the SLM, it would focus at spot 1 with distance f from the SLM plane. The quadratic phase factor can be considered as a lens against the SLM
[15,19], through Fourier Transformation of the lens with focal length f , the complex field of spot 1 can be expressed as i x,y i f (x2 y2) 1U1 x ,y F ee f (3)
and then, after a lens with focal length f images spot 1 to spot 1 at position z f2f from

the front focal plane of the lens f with a magnification of M ff , as reported in [18], the complex field of spot 1 can be expressed by i z22(x y) i x,y 1 f2U1 , ,z F ee f (4)
where (ξ,η) is the spatial-frequency coordinates with a unit λf/D for convenience, and D is the aperture of SLM.
The field of multiple needed 3D spots UH(ξ,η,z) generated by phase-only hologram H inducing a phase modulation of φH(x,y) can be calculated using a 3D hologram generation algorithm, for example, Fresnel-modified iterative Fourier transform algorithm (IFTA) [19]. In order to adjust the total power of these spots, a new phase profile displayed on a SLM is formed by directly superimposing binary phase grating BG with original phase-only hologram H as,
x,y H x,y BG x (5) #141925 - $15.00 USDReceived 28 Jan 2011; revised 23 Mar 2011; accepted 10 Apr 2011; published 18 Apr 2011
(C) 2011 OSA25 April 2011 / Vol. 19, No. 9 / OPTICS EXPRESS 8501
热门文档