文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 机械/仪表 > 英译汉The Two-Dimensional Dynamic Behavior of Conveyor Belts
侵权投诉

英译汉The Two-Dimensional Dynamic Behavior of Conveyor Belts

辛苦弄得,希望能对你有用处,带来方便

Engineering, Delft University of Technology, one of the three Dutch Universities of Technology.

4--------The interaction between the conveyor belt properties, the bulk solids properties, the belt conveyor configuration and the environment all influence the level to which the conveyor-system meets its predefined requirements. Some interactions cause troublesome phenomena so research is initiated into those phenomena which cause practical problems, [1]. One way to classify these problems is to divide them into the category which indicate their underlying causes in relation to the description of belt conveyors.

5---------The two most important dynamic considerations in the description of belt conveyors are the reduction of transient stresses in non-stationary moving belts and the design of belt-conveyor lay-outs for resonance-free operation, [2]. In this paper a new finite element model of a belt-conveyor system will be presented which enables the simulation of the belt's longitudinal and transverse response to starting and stopping procedures and it's motion during steady state operation. It's beyond the scope of this paper to discuss the results of the simulation of a start-up procedure of a belt-conveyor system, therefore an example will be given which show some possibilities of the model。

3. FINITE ELEMENT MODELS OF BELT-CONVEYOR SYSTEMS

6--------If the total power supply, needed to drive a belt-conveyor system, is calculated with design standards like DIN 22101 then the belt is assumed to be an inextensible body. This implies that the forces exerted on the belt during starting and stopping can be derived from Newtonian rigid body dynamics which yields the belt stress. With this belt stress the maximum extension of the belt can be calculated. This way of determining the elastic response of the belt is called the quasi-static (design) approach. For small belt-conveyor systems this leads to an acceptable design and acceptable operational behavior of the belt. For long belt-conveyor systems, however, this may lead to a poor design, high maintenance costs, short conveyor-component life and well known operational problems like :

excessive large displacement of the weight of the gravity take-up device premature collapse of the belt, mostly due to the failure of the splices destruction of the pulleys and major damage of the idlers

lifting of the belt off the idlers which can result in spillage of bulk material damage and malfunctioning of (hydrokinetic) drive systems

Many researchers developed models in which the elastic response of the belt is taken into account in order to determine the phenomena responsible for these problems. In most models the belt-conveyor model

上一页第2页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email