存储器件学术论文
A Novel Flash Memory Cell and Design Optimization for High
Density and Low Power Application
Huiwei Wu, Shiqiang Qin, Yimao Cai, Poren Tang, Zhan Zhan, Qianqian Huang, Ru Huang
Institute of Microelectronics, Peking University, Beijing 100871, China
caiyimao@pku.edu.cn
*
Abstract — A novel flash memory cell based on Tunneling Field Effect Transistor (TFET) is investigated via 2-D device simulation in this paper. The proposed flash memory cell shows improved program/erase speed, increased programming efficiency and super punch-through immunity as the cell gate length scaled from 180nm to 45nm, which indicates that this new structure is with strong scalability. Furthermore, cell design consideration i.e. ambipolar suppression for the TFET-based flash cell are also investigated and discussed.
Index Terms — Flash, scalability, TFET (Tunneling Field Effect Transistor), low power.
I. INTRODUCTION
The development of flash memory technology over the past decade has been one of the driving forces behind the tremendous growth in digital consumer applications [1]. One of them, NOR-type flash memory is widely used in code storage area due to its fast random access speed. However, the low programming efficiency using channel hot electron injection(CHI)[2] and high drain voltage which cause unwanted drain disturbance in other cells connected to the same bit-line[3] and drain to source punch-through (PT) effect bring great challenges to the conventional Nor-type flash memory.
In this paper, we investigate the performance of a novel flash memory cell based on Tunneling FET (TFET) [4] as scaling and its design optimization by two-dimensional simulations. Results show that the TFET-based flash memory exhibits higher program/erase speed, increased programming efficiency and excellent punch-through immunity when scaling, indicating that it is a promising structure for ultra-scaled and low power flash memory application. In addition, the cell design consideration is thoroughly discussed, in which the approaches and the corresponding parameters/process windows to suppress ambipolar problem[5] are specifically investigated.
II. DEVICE STRUCTURE AND SIMULATION SETUP As shown in Fig. 1, the structure of memory based on TFET is a gated p-i-n diode and the gate-controlled band-to-band tunneling at the source side contributes to channel
current during program and read operation. It is worth noting that we use underlap region between the drain and the stacked gate to avoid ambipolar behavior[7].
In our simulations, static and transient simulations in TCAD Sentaurus were performed to evaluate the performance of the proposed flash device. Specifically, a local band-to-band tunneling (BTBT) model was employed to simulate gate-controlled tunneling current. For channel hot electron injection (CHI) during programming, lucky-electron model with electron temperature calculated by hydrodynamic transport is used, while FN tunneling model is used during erasing.
Gate
Fig. 1.

III. RESULTS AND DISCUSSION
A. Performance of Scaling TFET-Based Flash Memory In order to estimate the scaling performance of the TFET-based flash memory, we change the channel length Lg from 180nm to 45nm. Fig. 2 shows the programming and erasing characteristics of TFET-based flash with different Lg, using CHE injection and FN tunneling respectively. Results shows that the reduced channel length Lg offers a faster programming and erasing speed, implying the better program/erase performance can achieved as the cell scales.
Here the ratio of floating gate current (Ifg) and drain current (Id) during programming is used to characterize the program efficiency. Fig. 3(a) shows Ifg and the program efficiency Ifg/Id are increased with decreased Lg, indicating an enhancement for programming efficiency as well as program speed.
As the flash memories continually scale down, the punch-through (PT) effect seriously challenges the NOR flash memory for high density application Fig. 3(b) shows the punch-through voltage (Vpt) vs. Lg for TFET-based
978-1-4577-1997-4/11/$26.00 ©2011 IEEE
FLASH MEMORY TECHNO... 16页 1下载券 Low Vol...A novel f las h me mory cell wit h st acke d st ruct ure ( Si su...
Flash memory erase mechanism is not self-limiting ? Threshold voltage can be low enough to turn the cell into a depletion-mode transistor ? Fault ...
8. 2000 What is Flash Memory ? EPROM EEPROM Flash EPROM Cell o EEPROM 100 A o Flash Memory TR. Cell program 250 A 1? Hot Electron 100 A 2? ...
A novel supercapacitor-fuel cell hybrid cell_专业资料。A monolithic hybrid fuel cell (MHFC) with a novel configuration was proposed in an effort to improv...
Introduction to Flash memory_计算机软件及应用_IT/计算机_专业资料。Introduction...varying the number of electrons placed on the floating gate of a cell. ...
Japan Abstract-We propose a novel 300 MHz embedded flash memory for dual-...cell C AZ C BL t L W dV dt I ref C AZ C in I cell C BL C ...
A novel cell search scheme for OFDM cellular systems_专业资料 暂无评价
2Tr 1Cell Flash Memory ? Single or Dual Power (1.8V or 3.3V) ? 1Tr 1Cell EPROM EEPROM 100 A Flash Memory Cell structure 450 A No. of transitor...
嵌入式快闪存储器(Flash Memory)技术_信息与通信_工程科技_专业资料。1 概述 随着...读出存储的数据,我们设计的 0.5μm 的 Cell“1”电平时读出电流可达 70μA...
They are different from standard hard drives in that they employ a large ...memory cell MLC versus SLC (continued) MLC NAND Flash will lead in the ...
热门文档