Hans Journal of Chemical Engineering and Technology 化学工程与技术, 2012, 2, 1-6
doi:10.4236/hjcet.2012.21001

Published Online January 2012 (doc.guandang.net)
The Simulation of Byproduct Steam Hydrogen Chloride
Synthesis Furnace
Shan Chen, Nan Yang, Fangyuan Shao, Shun’an Wei
College of Chemistry and Chemical Engineering, Chongqing University, Chongqing
Email: cqcshan@163.com
Received: Nov. 18th, 2011; revised: Dec. 20th, 2011; accepted: Dec. 23rd, 2011.
Abstract: Hydrogen chlorine (HCl) is synthesized by hydrogen and chlorine in the industry. Making full use of the reaction heat is our long-term goal in the design and operation process of HCl synthesis furnace. The model of reaction and heat transmission in the furnace is established on the byproduct steam HCl synthesis furnace. The simulation calculation is conducted by the method of infinitesimal section integral and the results are according with actual wo- rking conditions. The results show that: the radiation heat transfer is predominant in the whole heat transfer process and its heat transfer quantity is 9 times higher than convective heat transfer; Most of reaction heat is taken away by by- product steam and the ratio of energy utilization is up to 69.58%; The major loss of effective energy is in the generation system of stream and the effective energy of byproduct steam is only 37.71% of the whole effective energy.
Keywords: Infinitesimal Section Integral Method; Radiation Heat Transfer; Simulation Calculation; Effective Energy
副产蒸汽氯化氢合成炉的模拟计算
陈 珊,杨 楠,邵方元,魏顺安
重庆大学化学化工学院,重庆 Email: cqcshan@163.com
收稿日期:2011年11月18日;修回日期:2011年12月20日;录用日期:2011年12月23日
摘 要:在氢气和氯气燃烧合成氯化氢的工业过程中,充分利用燃烧热是氯化氢合成炉设计和操作的长期目标。本文通过建立炉内反应及传热模型,采用微元段积分方法对副产蒸汽氯化氢合成炉进行模拟计算,计算结果与实际工况相符。计算结果表明:在整个传热过程中,辐射传热占主导地位,辐射传热量约是对流传热量的9倍;副产蒸汽移走了大部分反应热,能量利用率达到69.58%;蒸汽发生系统的有效能损失较大,副产蒸汽有效能为总有效能的37.71%。
关键词:微元段积分方法;辐射传热;模拟计算;有效能
1. 引言
在我国,传统的氯化氢生产设备主要是钢制水夹套式合成炉。近年来,随着企业对产品质量和节能降耗的更高要求,副产蒸汽氯化氢合成炉(以下简称“蒸汽合成炉”)逐渐获得了更广泛的采用。蒸汽合成炉不仅解决了水夹套合成炉循环水负荷量大的问题,而且有效的回收了合成反应热。在能源日趋紧张的形势
下,推广使用蒸汽合成炉对于节能减排、提高企业竞争力和建设友好型社会具有十分重要的现实意义。但是,现有蒸汽合成炉存在设计缺陷,一般认为炉内介质均匀一致且不考虑辐射传热,因此,造成了这种设备在实际生产中,产生局部高温腐蚀、反应热利用率低等问题[1,2]。
针对上述问题,本文对蒸汽合成炉建立对流传
Copyright © 2012 Hanspub 1
热门文档