Composite Structures (1996) 45-58 36 0 1997 Elsevier Science Ltd All rights resewed. Printed in Great Britain 0263-8223/96/$15.00 ELSEVIER Pll:SO263-8223(96)00064-5
Finite element analysis of ply-by-ply and equivalent stress concentrations in composite plates with multiple holes under tensile and shear loading J. M. Henshaw,“* J. R. Sorem Jr”& E. H. Glaessged uUniversity of Tulsa, Department of Mechanical Engineering, Tulsa, OK 74204-3189, USA hVirgkia Polytechnic Institute and State University, Department of Engineeting Science and Mechanics, Viqinia, USA
The finite element method is employed to analyze the stress concentration effects of multiple holes in laminated composite plates. The analysis considers the composites both as homogeneous orthotropic plates producing an equivalent property solution, and as laminates consisting of laminae of various orientations, each having its own stress concentration. Theoretical verification of special cases of the analyses are described. Finite element results for[O/k 45/O],, and[O/+45/90],, laminates loaded in tension or shear are presented. The results are condensed into‘design curves’ to allow the designer to estimate stress concentrations. These curves allow comparison of stress concentrations on a lamina or laminate basis, for tension or shear, and for the number, size and relative position of holes. It is concluded that the presence of multiple holes tends to increase stress concentration over that which it would be if there were only one hole. Certain sizes and locations of holes also tend to increase stress concentration. 0 1997 Elsevier Science Ltd. INTRODUCTION
This study is concerned with the synergistic effects of multiple holes on the stress concentrations in laminated composite plates. While numerous investigators have studied the effects of single holes in composite plates, little information exists to aid the designer in dealing with the effects of multiple holes in close proximity to each other. Multiple proximate holes are an important design consideration in aerostructures and other applications, where the holes are needed for access, weight reduction and other reasons. (The analysis presented here applies only to‘unloaded’ holes. That is, it does not extend to pin-loaded holes.) The available literature dealing with the interaction of multiple holes in orthotropic plates is limited. Previously, theoretical, experi*Department of Mechanical Engineering, Tulsa, OK 74204-3 189, USA University of Tulsa,
mental and finite element work has been done on multiple holes in isotropic plates. Likewise, single holes in orthotropic plates have been studied using the same techniques.
Fig. 1. General
case of the geometry for the finite element analyses.
45


































Finite Element Analysis of an Involute Spline(...It is also shown that stress concentrations exist... there are no equivalent American standards for ...
Finite element techniques were used by Benchekchou ...stress concentrations in and around an optical ...composites with embedded optical fibers, it was ...
Finite element analysis of smart functionally ...stress intensity factors of graded composite plate ... and piezoelectric properties of these composites. ...
Composites Fatigue Lesson 8 3 Structural analysis ...most common application of the finite element ...stress concentrations A formal fatigue evaluation ...
FGMs? are the new generation of composites and ...Finite element method was also applied to analyzed...stress concentrations in thin plate with cutouts, ...
stress concentrations within the constituents of the...finite elements Original Research Article Composites ...(equivalent single-layer laminate model), the ...
Keywords Laminated composites . Cutout . Buckling . Finite element analysis ...the vicinity of the cutouts where large stress concentrations are anticipated....
Improved Submodeling of Stress Concentrations — ...Title: Finite Element Analysis and Optimisation of...Failure Prediction in Wood Composites — by Mr. ...
(FGMs) is a new kind of composites whose ...stress concentrations developed in conventional ...graded circular plates using finite element method....
Stress concentrations; B. Layered material; B. ...composites in recent years (Shindo et al., 2000...Finite element analysis of cracks in ferroelectric ...
热门文档