PAPER[3+2] Cycloaddition between Hydrazones and Cyclopentadiene
C

Figure 2Proposed transition state structures for [3+2] cycloaddi-tions catalyzed by TMSOTf (TS 1) and chiral BINOL-phosphate-derived silicon Lewis acid (TS 2); R=C6H4(4-NO2)

at room temperature; 15 mol% of BINOL phosphate wasused to ensure the full complexation of silicon. The reac-tion was first carried out with BINOL phosphate 3¢ with-out the use of silicon additives as a reference. The syn(dr=99:1) product was obtained in 13% yield and 47% ee(Table2, entry 1). Running the reaction for three days at–20°C, and using SiClsyn product (dr=96:4) was obtained in 18% yield, but in2Ph2 as an additive (entry 2), thehigher enantioselectivity (80% ee). Addition of 4 Å MS tothe reaction mixture raised the selectivity of the reactionto 89% ee (entry 3).
Table 2Asymmetric [3+2] Cycloaddition of Hydrazones and Cy-clopentadiene
EntryAdditiveYield (%)adrbee (%) (syn)b1–1399:1472SiPh2Cl21896:4803cSiPh2Cl21395:5894
SiPh3Cl
–
–
–
a Yield of the isolated product.b
Determined by HPLC. c
MS 4 Å were added to the reaction mixture.
Lastly, SiPh3Cl was used as an additive (entry 4). In thiscase the reaction did not take place, suggesting that theproposed TS 2 is plausible: however, the lack of a leavinggroup hinders the binding with the hydrazone. The lowyields may suggest that there is a problem with the regen-eration of the catalyst after the product is formed.
In summary, we have developed a novel and practical cy-cloaddition of aliphatic aldehyde-derived N-acylhydra-zones with cyclopentadiene using catalytic amounts ofreadily available TMSOTf (trimethylsilyl triflate) as aLewis acid. This method has been expanded to the asym-metric reaction, delivering the product with high enantio-selectivity, but in low yield. With these novel insights inthe development of enantioselective silicon-based Lewisacidic catalysts, further investigations are currently inprogress in our laboratory.Commercial products were used without further purification. Hy-drazones were synthesized from commercial available hydrazinesand aldehydes, purchased from Sigma-Aldrich Co. or Acros Organ-ics. Cyclopentadiene was obtained from commercially available di-cyclopentadiene (Merck KGaA) through heating and distillation at205°C at atmospheric pressure. All solvents used were previouslydried using appropriate methods. Petroleum ether (PE) used refersto the fraction boiling in the range 40–65 °C. Column chromatogra-phy was performed on Acros silica gel 60A and TLC on Macherey-Nagel ALUGram® SIL G/UV254 plates. 1H NMR and 13C NMRspectra were recorded on Bruker Avance 400 (400 MHz; 2001) orBruker Avance 300 (300 MHz; 2001) using the solvent as internalstandard. Mass spectra [m/z, relative intensity (%)] were obtainedwith a Shimadzu AXIMA Confidence - MALDI Time of Flight(TOF) or Micromass ZabSpec FAB mass spectrometer; DCTB =2-[(2E)-3-(4-tert-butylphenyl)-2-methylprop-2-enylidene]maloni-trile; DHB = 2,5-dihydroxybenzoic acid; w/o m = without matrix.HPLC measurements were recorded on Agilent 1200 Series system.TMSOTf-Catalyzed [3+2] Cyloaddition of Cyclopentadiene to Hydrazones; Typical Procedure
To a solution of TMSOTf (1.9 mL, 0.0113 mmol, 10 mol%) inCH2Cl2 (2 mL) were added hydrazone 1i (30 mg, 0.113 mmol) andfreshly distilled cyclopentadiene (200–300 mL). After stirring for 24h at r.t., the reaction mixture was quenched by the addition of sat.aq NaHCO3 (10 mL) and extracted with CH2Cl2 (3 × 20 mL). Thecombined organic layers were dried (MgSO4), the solvent was re-moved under reduced pressure, and the residue purified by silica gelcolumn chromatography (EtOAc–PE, 1:1) to afford product 2i.2b13
C NMR (100 MHz, CDCl3): d=30.89, 33.88, 43.90, 64.62, 69.55,122.15, 126.17, 127.63, 128.10, 128.36, 128.43, 129.61, 134.92,137.53, 140.86, 147.95, 165.61.
MALDI-MS (DCTB): m/z=350 [M + H]+, 390 [M + K]+.1
H NMR (400 MHz, CDCl3): d=2.34 (m, 1 H), 2.54 (d, J=16Hz,1 H), 2.66 (m, 1 H), 2.84 (m, 1 H), 3.09 (m, 1 H), 3.40 (m, 1 H), 4.01(d, J=13 Hz, 1 H), 5.50 (d, J=7 Hz, 1 H), 5.82 (m, 1 H), 5.95 (m,1 H), 7.10–7.29 (m, 5 H), 7.79 (d, J=9 Hz, 2 H), 8.10 (d, J=9Hz,2 H).
2c1
H NMR (400 MHz, CDCl3): d=1.75 (m, 2 H), 2.40 (m, 2 H), 2.63(m, 2 H), 3.10 (m, 2 H), 3.73 (d, J=12 Hz, 1 H), 5.57 (m, 1 H), 5.80(m, 1 H), 5.96 (m, 1 H), 7.0–7.4 (m, 5 H), 7.81 (d, J=9 Hz, 2 H),8.19 (d, J=9 Hz, 2 H).
13C NMR (100 MHz, CDCl3): d=14.65, 21.49, 30.46, 31.45, 33.66,44.58, 60.82, 63.54, 70.22, 123.09, 126.64, 128.71, 128.91, 130.39,135.76, 141.32, 142.00, 148.84, 166.82.MALDI-MS (DHB): m/z=364 [M]+.
Synthesis 2011, No. x, A–E© ThiemeStuttgart·New York
Downloaded by: Duke University. Copyrighted material.
有机小分子催化讲解_环境科学/食品科学_工程科技_专业资料。今日推荐 88...有机小分子催化环化 5页 1下载券 手性有机小分子催化最新... 18页 1下载...
第24 卷第 8 期 2012 年 8 月 化 学 进 展 PROGRESS IN CHEMISTRY Vol. 24 No. 8 Aug. 2012 * 有机小分子催化 ε己内酯开环聚合反应 许 茸 陈春霞...
化摇 学摇 进摇 展 灾燥造援 圆源 晕燥援 愿摇 粤怎早援 圆园员圆 有机小分子催化 着鄄己内酯开环聚合反应鄢渊 东北林业大学理学院化学化工系摇 ...
N_杂环卡宾_一种多用途有机小分子催化剂_能源/化工_工程科技_专业资料。2006 ...而且产物非常有价值, 反 应中涉及环化和季醇的立体选择性控制. 在这类反应 ...
有机双功能团小分子催化剂的研究进展_专业资料。在过去的10年时间里,有机小分子催化剂作为一门环境友好的有机合成方法学在不对称催化合成中的应用得到了重新发掘,...
有机小分子催化在不对称合成中的进展研究_化学_自然科学_专业资料。有机小分子...段德河等人报道了了手性磷酸催化的吲哚不对称 Michael 加成-环化串联 反应,反应...
有机小分子催化剂在不对称合成中的应用 教师:郭炜...-烷基化反应 1.8 L-Proline类似物催化丙酮和对...酮能高对映选择性的催化环戊二烯和不饱和醛发生的...
有机小分子在不对称催化中的...环糊精和杯芳烃 b. 分子印模 有机小分子催化不对称有机合成 脯氨酸及其类似物...
2]环加成反应论文 有机小分子催化的不对称“4+2” 环加成反应论文: [4 2]环加成反应论文:有机小分子催化的不对称“4+2”环 加成反应构筑四氢吲哚类化合物...
5, 618~626 ·综述与进展· 有机小分子催化的不对称羟醛缩合反应姜丽娟 a ...四元环次之, 六 元环活性很低, 而非环状结构的普通氨基酸几乎没有催 化活性...
热门文档