IC datasheet pdf-DS1876,pdf (SFP Controller with Dual LDD Interface)
SFP Controller with Dual LDD Interface
ABSOLUTE MAXIMUM RATINGS
Voltage Range on PMON_, BMON_, RSEL, IN1, TXF_, and TXD_ Pins
Relative to Ground ...............................-0.5V to (VCC + 0.5V)*Voltage Range on VCC, SDA, SCL, OUT1, RSELOUT, and TXFOUT Pins
Relative to Ground ...............................................-0.5V to +6VContinuous Power Dissipation
28-Pin TQFN (derate 34.5mW/°C) above +70°C ....2758.6mWOperating Temperature Range ..........................-40NC to +95NCProgramming Temperature Range .......................0NC to +95NCStorage Temperature Range ............................-55NC to +125NCSoldering Temperature .........................Refer to the IPC/JEDEC
DS1876
*Subject to not exceeding +6V.
J-STD-020 Specification.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
(TA = -40NC to +95NC, unless otherwise noted.)
PARAMETER
SYMBOLCONDITIONS
MINTYP
MAXUNITSMain Supply VoltageVCC(Note 1)
+2.85+3.9VHigh-Level Input Voltage0.7 x VCC + (SDA, SCL)
VIH:1VCC0.3VLow-Level Input Voltage(SDA, SCL)
VIL:1-0.30.3 x VCCVHigh-Level Input Voltage(TXD_, TXF_, RSEL, IN1)VIH:22.0VCC + 0.3VLow-Level Input Voltage(TXD_, TXF_, RSEL, IN1)
VIL:2
-0.3
+0.8
V
DC ELECTRICAL CHARACTERISTICS
(VCC = +2.85V to +3.9V, TA = -40NC to +95NC, unless otherwise noted.)
PARAMETER
SYMBOLCONDITIONS
MIN
TYPMAXUNITSSupply Current
ICC(Notes 1, 2)
2.5
10mAOutput Leakage (SDA, OUT1, RSELOUT, TXFOUT)
ILO
1FA
(SDA, OUT1, RSELOUT, IOL = 4mA0.4
TXDOUT_, MOD_, APC_, VOL
V
TXFOUT)
IOL = 6mA0.6
High-Level Output Voltage(MOD_, APC_, TXDOUT_)VOH
IOH = 4mA
VCC - 0.4
VTXDOUT_ Before EEPROM Recall
10100nAMOD_, APC_ Before RecallFigure 1
10
100nAInput Leakage Current
(SCL, TXD_, RSEL, IN1, TXF_)I

LI1FADigital Power-On ResetPOD1.02.2VAnalog Power-On Reset
POA
2.0
2.75
V_______________________________________________________________________________________ 5
IC datasheet pdf-DS1877,pdf,datasheet,SFP Controller for Dual Rx Interface_信息与通信_工程科技_专业资料。IC datasheet pdf-DS1877,pdf,datasheet,SFP ...
IC datasheet pdf-ONET8531T,pdf(11.3Gbps ...ONET8531T With Dual Cathode PIN Diode Copyright ?...Products DSP Clocks and Timers Interface Logic ...
元器件交易网www.cecb2b.com Datasheet 8 Gbps Bi...(Duplex LC) Dual-fiber, bi-directional Class 1...2-wire Serial Interface Data Line (MOD-DEF2) ...
? Customer’s MAC should be setup for SGMII interface with Auto-Negotiation... IC datasheet pdf-DS187... 65页 免费 AN4138C(20G四通道SFP有... 20页 ...
datasheet 11页 免费 XFP模块电路设计 6页 1下载...Assembled with low EMI emissions IC and fully ...Interface GBIC 1000Base-X to 1000Base-T SFP-...
IC datasheet pdf-DS1876,... 69页 免费 AlGaNGaN+HEMT的研制 60页 免费 ... Normally Off AlGaNGaN Low-Density Drain HEMT (LDD-HEMT) With Enhanced ...
The resistor range for the laser current settings is optimized to interface with the DS1858 SFP controller IC. The MAX3735/MAX3735A provide transmit-...
interface Duplex LC connector Built-in digital ...Datasheet Digital Diagnostics Functions MRV’s SFP-...Controller (DDTC) inside the transceiver, which ...
dual-loop LDD, allowing one PC board layout to...APPLICATIONS 1×/2×/4× Fibre Channel SFP/SFF...Control with a Single-Ended Laser Interface Rev....
Datasheet MAX3735 - 2.7Gbps, Low-Power SFP Laser Drivers - Maxim ... settings is optimized to interface with the DS1858 SFP controller IC. ...
热门文档